| Subject | Text |
| Check if there is any tape transport problem that causes wrinkling of the lower edge of the tape at |
| Mitsubishi CS-31303 | this set has been acting funny for almost a year now. Sometimes you turn it on and you get a bright |
|
|
| Thanks for the warning mark.
I did put a load on each of the pins to make sure that it resonates |
| I agree with Miguel. if your mixer has PAN controls just turn all of them to the same end so your ch |
| Re: light bulb broke off the wires for main display | [quote:9d1879eb2d="Dean"]I have a 1995 RX-V850 Yamaha Stereo Rec. the through the hole light bulb ha |
| service manual marantz pm710dc | anyone a service manual fot marantz amplifier pm710dc
or sugestion to solve random rateling noise e |
| If the hum disappears completely when turning down the volume control, then the hum source must be b |
| tv graetz 2897 | Hy
i have vertical line
power suplay is o.k
electrolits capacitors replaysed
ta8427k also replas |
| Goodmans GCD709R | Anybody got a cct diagram for this, I need an extract of line output and volume control bits. Ta |
| Re: philips l01.1e | [quote:ad5ed54760="terminator2k2"]hi all just wandering if some one could help me.?? i have a philip |
| re; Mitsubishi | Hi, try inputting a dvd signal into "video input 1" then if you get a picture
it probably is a tun |
| Re: HELP stero repair | [quote:2890bb5678="tim in pa"]my first post, thanks for reading. i am repairing my bosses (i know!) |
| teac receiver- protect mode, all output transistors are ok. | like the title says, TEAC AG-V8500, I cant seem to figure out why this receiver is going into protec |
| Dead Black Diamond BD28WS | Hello to everyone this is my first post here. I have a BD28WS Black Diamond TV. The fault is when I |
| goodmans 28" widescreen | i have this goodmans 28" widescreen chassis 11ak19b-1, i dont know the model no. does anyone? its fa |
| sharp 27fs50 has sound but no pic anymore | Sharp model 27f-s50 has sound but no picture..turn the screen pot up at the screen and focus section |
| Trace Elliot Commando 1001 will trade for it | i need a circuit diagram for a Trace elliot 1001 commando bass amp i can trade from a large database |
|
|
| sansui A7 amplifier | The amp went dead and when cheked there is about 10V dc in the speaker out put terminal.Can anybody |
| re; Sony | Hi, might also be IK circuit, try turning up G2/Screen control just a little to the right,
Larry E |
| Testing the circuit is to be done with the power off!!
Do not apply power until you are sure you ha |
| [quote:e6a73c2eac="opal"]Thanks for the Info,
i have to addmit, im not into Musik really, so i dont |
| There could be many things...
I used to work with various Yamaha receivers & to the best of my |
| Re Finlux 1000 | I had the same problem about 3 years ago with this model.
Check continuity of line scan coils..shou |
| Hi Minnie
Thanks for your reply, the link to Binatone tech support line could be useful but the lin |
| I checked all the soldering and they all seem ok. I'm convinced that the problem is with the line tr |
| Sears 509-14370 TV, chassisA67 | Sears 509-14370 TV, chassisA67, made by JVC, the board is labeled CKF0822-DU3-1. TV turns on when f |
| DIY Disasters | This is a common problem with Onkyos. There are about 10 muting transistors located on the preamp bo |
| New "findings" | OK, no one seems to care about this thread, but I'll post my latest thoughts about the red-level iss |
| Your east west circuit is faulty, usually due to a dry joint in the line stage, may have taken out a |
| help me locate the flaut | hi there,
i got a problem with my pansonic tv. the problem is that there's a vertical line on th |