Subject | Text |
| you need to use a BDM device to reprogram it....there is a port inside your reciever which is use fo |
| This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after pay |
|
| This Parts & Service manual can now be purchased for $9.99 and downloaded immediately after paym |
Aiwa Tv, Model No TV-C201KER is not turning on, Help Plz. | Hi, I have Aiwa Tv of Model No TV-C201KER, but now it is not working, I have checked the power cord, |
Help on RPTV Sound | I have a Hitachi 61SWX10B about 3 1/2 years old. Recently the sound has been crackling and gets wors |
| ..did not know it had a mechanical volume control. As kenray suggested, try cleaning it with a clean |
eprom dump supra stv28p10 | tv name: supra
tv model: ST28p10
Chassis name: 11ak19p5 (printed on right side of board) on back |
re: dead set | Hi, If your led`s don`t stay lit your set has a short, check all of the
little chemical fuses near |
| DVD9000... Sure do remember the beast. Very nice & expensive unit. I use to work on them ..do ha |
aiwa nsx-f9 | Can anyone help with a service manual for an aiwa nsx-f9 stereo or help with problem when connected |
| I did't find a scheme of amp., but I checked parameters of the transistors. You can use IRFZ44 witho |
120 cycle hum of death! | I'm working on Kyocera receiver that is giving a nasty 120 Hz hum. It plays fine and sounds good onc |
| I'm going to assume (dangerous thing to do sometimes) that you are reasonably skilled at disassembli |
Monitor have single line horizontal.(BH41-10342B) | Hii..
I have a monitor whit single line horizontal,I had replace the Vertical ic : TDA9302H,but not |
| This monitor requires bot the H-Sync and the V-Sync to be the correct way up ie +ve going or -ve goi |
Sansui RZ-2500 service manual or schematics wanted | I have a Sansui RZ-2500 tuner/amp that only goes into standby mode but doesn't turn on. Any help ap |
Sony KP-53S15 won't power up. | Make: Sony
Model: KP-53S15 Rear Projection TV
Manf. Date: Sept. 1995
I bought this TV new from |
|
| Speakers and wiring are good. The distortion is there regardless of input - whether internal (tuner) |
Rotel RA980BX distortion | At the moment Im unfortunately working without a circuit diagram, but I do have the benefit of one c |
| Ok. So if it's the preamp, I'm thinking it would probably be something like a capacitor that was the |
NEC MT800G picture fault | Hi
I have problem with my NEC MT800G LCD projector, the picture are
"distorted". No fault with the |
Orion Studio 710 | Hello
Need schematic for TV Orion Studio 710.
Only horizontal line… I replace V out TDA8174W with |
vertical IC in your television | The vertical IC is never mounted on the crt board.
In modern TV's, it could be a TO220 device (TDA9 |
| Reinstall U31.
Disconnect other amp connector J7/MCON12.
Repeat resistance measurements to SAM |
| [quote:0c9202a23f="ronw_57"]Hook up was with composite cables to get high def picture.[/quote:0c9202 |
re; rca dead | Hi Guys, the power supply has failed in your set(s) without the
model & chassis number how do y |
New here, amp repair? | Hi people,
I'm not exactly well versed in electronics. I know how to be safe, I can solder and |
| Channel imbalance was in fact down to damaged speaker cable but nonetheless unit now back to factory |
Help Help Help Philips Schematic | Hallo and Happy New Year to all,
my 17" Philips Brillance 17A ([b:f77b93c13d]17A280BQ-02C[/b:f77b |
| Probably one (or more) of ceramic capacitors gives short to ground in power line. |