Subject | Text |
NEC PlasmaSync 4210W | I guess this is your lucky day, or maybe not. The reason your plasma unit keeps going into protectio |
Schneider STV-3600 | Hey,
I could use some help with this old TV. It is dead (but you can feel the high voltage on the s |
|
| Check Red color gun transistor at neck of crt or at mainboard. check also traces going to color sour |
| Like I mentioned, there was never any schematic for the SMPS and I do not have the one I drew some t |
| I found the X,Y and Z boards and disconnected them one at a time. No change. When you say disconne |
Varistor marks, and Panasonic E110 | Hello,
I am new in forum and also in electronics but I have a little knowledge from my education. N |
| Being a switchmode powersupply I would not run it without a load otherwise it may self destruct. Plu |
| thanks, NZtech, actually I disconnected the powersupply from the motherboard and I only connected a |
Onkyo A7090 Service and User Manuals | I'm searching for a source of the above manuals, if you've ever seen one of these beasts you'll unde |
UD3/5 CD tray problems | Katz2000
There are a lot of complementary references above but I can't find thye source they are |
PX-42VM3 | Hello Pinkwell,
What country are you based in ?? It would really depend on the answer i can give |
| measure dc voltage at bad chan. output with no load. if over 0.1vdc then driver amp (circuit prior t |
Re: Sony TV KV-35V76 ON and OFF picture | [quote="grizzley"]I have a Sony television Model KV35V76 where the picture is on for two seconds and |
| You could better replace the components which I called above.
BAV21-diodes can measure OK, even if |
| Hello Latino,
Thanks for the reply. Unfortunately, nobody here was able to help me locate a serv |
Sony FH-411R: CD line in Left channel faulty | Hi,
I need help with my Sony mini hifi model: FH-411R. There's no sound when I plug in a source t |
TV Crown CTV-5345 bad picture over SCART | I have a Crown TV set CTV 5345 and if I connect an external composite video source to the SCART conn |
|
servicemanual needed for philips pm3320 oscilloscope | Hello
Reacentlz bought pm3320 oscilloscope but it does not operate normally.
it does turn on a |
Samsung Syncmaster 955df - HELP | My monitor is working at high brightness level. The correction level is set to "0", but the brightne |
| Device Name: Dinamap 845
Company: Applied Medical Research
Function: Measure Systolic and Diastoli |
| Thanks for the warning mark.
You are correct that this did lead me to a good path...perhaps the l |
| http://www.mcmelectronics.com/search.aspx?C=&K=tact%20switches&T=
Digi-key would be anoth |
Philips DVDR 630 VR NO DISPLAY | Hello can anyone help got a dvdr 630 vr NO DISPLAY NO WORKING PUSHBUTTONS ON FRONT PANEL BUT WILL SW |
| How is the set stuck in standby? Are there any sounds coming from the back of the TV when you switch |
| All CRT's emit X-rays. It was more of a problem with older sets. It is your job as the service perso |
RCA TROUBLEshooting | DEAR
IT APPEARS THAT SOME PART IS SHORT INSIDE THE TV.IF THE SOUND IS LIKE CRACKERS RECTIFIER DIO |
Looking for a part for Grundig Classic 960 | I'm trying to repair a Grundig Classic Model 960 (vintage reproduction) for a friend. It's about 2 |
Samsung SyncMaster 1100df CRT monitor: pwr LED OK but... | I have a Samsung SyncMaster 1100df CRT monitor that produces no picture but much of the circuits see |
Hitachi CPT-2100 | because the fuse of this television set is burned, it has in the source str 6020 |
| Can you hear any high voltage, when the TV starts?
if not, try to measure the secundairy voltages |