| Subject | Text |
| I do have an older Braun(not the exact model) which I use daily. Unless there is something special a |
| Backlights, inverter.
What does audio do during this sequence? |
|
|
| There should be a sequence of buttons to push to get to factory default. this would be in a service |
| sony kv32xbr96s blinks | hi
i have 2 troubles with my sony
backgroung is suppose to be black but now with dim green also |
| replace the ic close to the flyback.16 or 18 pins for high voltage startup.---3001.
Cory you mean |
| 5.5 The Blinking LED Procedure
5.5.1 Introduction
The software is capable of identifying different |
| Poineer KE-8003zh-02 Car Stereo Wiring Connections Diagram | I need to know the sequence of the wiring connections on this model Pioneer.
Thanks in advance resp |
| Service Modes | Manufacturer Model Chassis Product Mode Enter
Akai CT-2119 CTV Test Mode
Simultaneous press + & |
| E04 | This error is related to the drum motor. If the drum motor is not running or fails to servo during s |
| A solution for the Acer AL1511 "no signal" blackou | Hi y'all. I think this might resolve the problem...
On the Acer AL1511 are some control buttons (AU |
| check main ac fuse, on many panasonic models the main fuse goes on startup because degauss circuit g |
| Nissan Primera SVE Service reminder Info Please | Anybody know how to enter and cancel or alter the service reminder?
The car has 4 reminders for ser |
| Decca D20RFG5 Fault | This has an intermittent fault. The set cuts out and the led flashes. I haven't actually seen the fa |
| Sony DAV-HDX900W Home Theatre Systems | Tray will not open as system goes through its POST sequence. Seemingly DVD tray is stuck. Appears to |
| I don't have any ideas on the exact problem but it could be a resistor changing value as it heats up |
| RCA D52W23 ICT222 | My television blinks 3 times and never comes on. I think what I have gleaned by searching on the we |
| Troubleshooting Tips (ref. Figure 3-3)
NOTE: Follow previously discussed “IC6501 Startup Sequence”. |
|
|
| Philips TV 4428 remote control codes | I have a Philips TV PT4428 .. and the last time some serviceman came in he "adjusted" the horizontal |
| Panasonic repair | There do not seem to be any problems with the loading, I've checked all codes and none are displayed |
| Samsung Max DX55: Audio System problem | Dear Experts,
My audio system is behaving weird. Samsung Max DX55. Here is a link to the produc |
| i put in the new drive and bios cant detect it but when i put the startup disk in and start with cd |
| I have seen this so many times- the IHVT(Lopt-flyback) fails from the repeated stress of startup- us |
| toshiba 42hp66 bad y-sus board | I have a toshiba 42hp66. The y-sus board (6871qyh053b) failed and has been replace. On power up th |
| Re: samsung projection tv | [quote:2ff0abc0c9="garster59"]how do I enter the service mode in the tv with the remote[/quote:2ff0a |
| RCA PHD50500 Trap Switch | I believe I have gotten a PHD50500 locked... the standby LED begins flashing red/green as soon as it |
| RCA 52" Projection | My RCA 52 Inch projection TV has an issue ..
Plug it in , it turns on ,, then off then on then of |
| Not really. The LOPT, deflection and capacitors form a resonant circuit which produce the high volt |
| Before the startup process, my show screen separates into two then enclosed in straight and horizont |
| Rather than reviving an old thread about nomenclature; remember;
[u:c1d66140c0]You have two major |
| RCA Rear Projection P61929 | Can anyone help? My RCA 61 rear projection TV (model # P61929) menu comes up on the screen while we |