| Subject | Text |
| Grundig Super Color 8450 - schematics | need schematics data on that old TV is in a good state but my little friend "play" with him so right |
| I have what sounds like a very similar or the same problem with a 6 yo Toshiba CN36H90. I played ar |
|
|
| I have seen the caps go leaky, basically turn into a resistor. it wont read shorted but when voltage |
| Intercom buzz | Lots of faults can cause buzz, but no ground or poor or corroded ground connections on shields is a |
| Thanks! | Hi there,
Just a quick post to thank everyone in this thread for the solution to the RX-V650 powe |
| Guys I need some guidance | if a delicate cable as the one connecting monitor with cpu is cut can it be fixed? and if yes how? |
| RCA 60-inch projection TV - suddenly no power | What are the chances? The same thing happened to my RCA TV 2 days ago. Worked fine when turned off |
| Re: Toshiba CF27E50 | [quote:463007264d="draeservice"]Hello,
I have a Toshiba CF27E50 television. When I turn it on, i |
| HUGE sigh of relief ! | I was bordering on bummed out, :? hoping there was nothing wrong with my monsters.. I will defi |
| No Sound from Onkyo | This is a signal tracing task. Signal tracing is the most basic trouble shooting technique after si |
| philips 29PT5515/01 random switch to EXT1 | a noise signal is getting through EXT1, making the tv to automatically switch to that channel, back |
| sony kv28wt72 engliah manual needed | Hi!
I badly need a sony kv28wt72 manual my cable does not get all the channels
PROBLEM: my tv |
| Service Manual for a Sony CPD15SFII Trinitron Monitor | Hey guys,
I am looking for a service manual for a Sony CPD 15SFII Computer Monitor. I need the |
| Toshiba SD-V291 VCR/DVD combo ejects tape immed after load | Hi. Above noted machine loads tape, but then imediately ejects the tape. I removed the cover and t |
| av input | First try a different scart lead, then check for dry joints or cracks around the connecting pins of |
| Re: Proview BM568 VGA Cable Pin Outs | [quote:6133c70609="HT"]Hi,
I have a Proview BM568, but the VGA connector needs to be replace. Doe |
| Toshiba TV quits @ bright light | Hi everyone,
I know very little about electronics but I wanted to exhaust all my options before cal |
|
|
| 3.5: floppy ribbon won't match motherboard 34 pins. | what cable do i need to install my 3.5" internal floppy drive into the motherboard #MS-6577 Ver. 4.1 |
| I don't habve any specific IC to recommend.
But check out
http://www.electronics.ca/reports/mu |
| I usually just take a magic marker and draw a line across the control - that is across the movable p |
| Old Rank arean stereo similcast video recorder DIN plug conf | Can anyone please tell me the wiring diagram for the DIN plug out of a Rank Arena Video reorder to R |
| How your wires (especially speakers) are routed around/by/through areas. For example you never want |
| monitor trouble | I have a problem with my monitor - the red color turned black and the green is pale. After some time |
| Hello, check the resistor value of the pin 21 and 22 of the flat cable lens.
If this value is to of |
| Re: Hp L1702 Monitor | --------------------------------------------------------------------------------
I have a Hp 170 |
| jd75125 addendum PVY4665RK | :) Sorry Larry E, I did not provide much info. after taking more detailed
look at TV, here are wha |
| soldering always getting a dull finish, dry ? | hi,
i bought a soldering atation and doing a bit of soldering work on a curcuit board,\
howeve |
| Base station | Just re reading your post.
The base station will not only charge the handset but also picks up th |
| Projection TV turns itself off | I have a weird projection TV problem. This is a 55-in Pioneer, which turns off by itself. This start |
| Ravi Fixit
Hi mate i have the same problem on same monitor,been all over the web to get a cable but |