Subject | Text |
Re: Iso-Trans | [quote:2dd8bbb15e="PackratKing"]OK maybe the Packrat is shooting himself in the foot.
I have sev |
cd changer leads | Hi everyone,
Can anyone help with a wiring schematic for a cd changer lead from a renault scenic |
|
Fujitsu plasma SOT ID | I have a PDP driver board and I need to ID 2 components They are a SOT case with 3 lead on one side |
| A two prong power plug means that the device is double insulated and either requires no earthing or |
Cut-off monitor connector | [quote:e80699bafd="JaniDoe"]
Monitorkabel Compaq S7500
Orgineel
1. roze (groot)
2. wit |
| Testing the circuit is to be done with the power off!!
Do not apply power until you are sure you ha |
| I would check the high voltage block, it is common in rca projections that this part goes down....it |
RCA F36669 36" Direct View Television | Have a RCA F36669 36" Direct View Television I purchased used. Problem is that the Cable/Antenna con |
service manual for montgomery ward tv | I found this old montgomery ward tv and thought I would use it in my shed
(yes I did say shed) bec |
dp42sp | hi, im new here. I have a 42' plasma dawoo that broke yesterday. the bottom half of the screen wen |
Re: Samsung Syncmaster 711MP LCD TV Monitor -Not Powering Up | [quote:e8914f791a="Anonymous"]I had Same problem. - Now Repaired -
Three of the Five Electrolyt |
RCA D52W23 ICT222 | My television blinks 3 times and never comes on. I think what I have gleaned by searching on the we |
| I have same tv but after replacing capacitors still no picture on screen. Standby red light comes o |
Sony AE5 Chassis Nightmare! | Sony KV28FQ75A (AE5 Chassis).
This set came in with a blown chopper IC and 0R1 resistor and blown |
Mitsu 35" | We also have raining blue streaks with sound OK on our 35"... 12 years old. Found this on another s |
| this is a known fault on these sets, resolder ic701 on b3 pcb, do not attempt unless you are comfort |
| I do not have specific information concering this monitor.
The colors on the monitor cables are no |
|
CDC2 to CCR600 | Please could someone help me. :cry:
I have aquired a blaupunkt cdc2 disc changer and wish to con |
| Hi Minnie
Thanks for your reply, the link to Binatone tech support line could be useful but the lin |
Old CRT televisions - interesting failure report | Hi everyone,
I am new here & thought this might interest readers & its not a help request. |
Circuit dia of SONY KV-J21MN1 21" colour TV. | Please does anyone have the circuit diagram of SONY TV
Model number: [b:39e1f31a82][u:39e1f31a82]K |
| Thank you, Darko. That was very helpful, but not fully.
I'll try to explain what my problem is...
|
need pinout for compaq | Hi all
need pinout for compaq or details on wiring or where i can buy new cable.
Have tried all ov |
Problem with Yamaha DSP-AX620 - help/advice required! | Hi,
My Yamaha DSP-AX620 AV amplifier switches itself off immediately after I switch it on. This |
Looking for a part for Grundig Classic 960 | I'm trying to repair a Grundig Classic Model 960 (vintage reproduction) for a friend. It's about 2 |
Proview BM568 VGA Cable Pin Outs | Hi,
I have a Proview BM568, but the VGA connector needs to be replace. Does andyone have the pino |
| Ok 1st things 1st I may have miss lead you on the last test
those High voltages may have been Mv I |
Changing the channel for record. | Ok, this has been very annoying for me. My VCR wants to record what's on channel 4 on my TV. My cabl |
| TV is on cable enstead of broadcast or local antenna.
On cable setting the uhf channels are in th |
| sHep here.
i need some clarification with terminology.
-''connect a ground wire between the cha |