Subject | Text |
Sony KVX-2552U | Just wanted to add a little bit to the repair tip for this model. I read the tip for intermittent co |
re; service costs | Joe, first of all you shouldn`t have stopped payment on his check,
he came to your house as YOU req |
|
| I had a friend that thought the transistor went bad. He does know a bit about electronics but not s |
| Try replacing burnt/shorted hi-volt cap C421 470pf/2kv. |
Dell D1626HT Sony trinitron monitor.. needs fix please help | okay. im a micro-electronic engineer student in australia and i'm trying to fix my friends monitor. |
| I have the exact same problem as the photo. Two thirds and streaky and everything. I'd like to think |
connector pins for fsp212-3f01 | This is taken from the fsp212-3f02.pdf. Warning this is not exactly the same as 3f01 but it seems to |
Sharp Aquos LC-52D62U, dead and pwr light flashes 4 times | When you try to turn the set on, there is a small patch of white flashing on the screen and then the |
| The Painter IC is the cause of your problem....replacement is the only fix.
If you are going to a |
Re: vertical Line | [quote:1a03dd7fb2="zamani"][quote:1a03dd7fb2="kmarm"]I have a Sanyo TV MOD. DS31590 it has a 1/8 in |
Philips TV IR Receiver not responding as expected | Our Philips Blackline S TV (29PT5322) Remote sensor doesn't respond accordingly to some of the butto |
Philips #27PT6441/37 Will Not Turn On! - UPDATE!! | I finally took it in to a shop for repair and saw [b:2d120d15d9]FOUR[/b:2d120d15d9] sets JUST LIKE M |
Toshiba FC22 Copier Problem | We have a problem on our hands and I need some help.
First of all, let me say, I'm not a copier r |
| I do not agree with Dfarhen, if you do not know what you are doing or do not have a tester for the c |
| It sounds like a verticle deflection problem. You can try replacing the verticle output IC and assoc |
sharp geometry problem (pincushion) | Dear Mario,
I guess that "RESOLDER THE FLYBACK CAPACITORS IN THE LINE OP STAGE" means replacing b |
convergence | well R3243 the 110K Ohm or 120K Ohm resistor (both values have
been used by Zenith) should be repla |
|
| Again a few new questions:
item 1) Do you have high voltage on the CRT? And if so, when turning u |
RCA's new service menu | I was working on a fairly new RCA projection (R52WH74) and tracked down the new service menu access |
| [quote:ad11cb86e0="mrroboto"][quote:ad11cb86e0="minnie"]Not short of replacing the SSB "small s |
| LCD sets are still board replacement only. Most manufactures don't even provide schematics for the b |
JVC GM-V42UG plasma monitor problem | Hi all. I'm new to tv repair and plasma/lcd technology. However I know my way around pc motherboards |
| Unless you have some experience with mixing boards, that is not something to tackle. You'd at least |
| Philips part #483531057554. This remote puts the tv into a service mode, or it should. My biggest pi |
Hitachi 50UX58B | Found quite a few parts are still available from original manufacturer. There are quite a few parts |
transformer smokes | I am repairing a power supply for a scientific instrument. When I recieved it, it would not turn o |
Re: Blinking green light of death | [quote:09f2614160="zee"]Hello, I hope someone here will able to help me out. Im having problem w/ Mi |
am I getting hosed on repair costs? (Hitachi 50UX58B) | Okay - my 50" Hitachi Ultravision - 50UX58B (1998) set went bad days before my Super Bowl party. I r |
| I don't think the filter capacitors should be affected, it is more likely that the problem is leakag |
| What you seem to experience here is called "chanel drifting". In most cases replacement of the tune |