| Subject | Text |
| There is no change after changing caps.
Nobody has any idea???? |
| helicopter | try changing RGB card part number 1-658-264-15 |
|
|
| A couple of shops near where I work do it by changing a chip on the cd player and adding a jack for |
| Hi
Don’t think about the colors (values) of the resistances, be sure.
The resistor 1 is 560 Ohms & |
| 11AK19 PRO | Hi
I have a Black Diamond BD2851s (Vestel 11AK19 Pro I think) 4:3 28" Tube
The original fault |
| Sony Vega KV-32FS100 "Initial Setup" Screen Won't | Whenever I turn on my Sony Vega, the black box that reads:
Initial Setup
Auto Program (Chan + |
| Re: ATX Power Supplies | I am pretty sure that all ATX switching power supplies require
a load to operate. Which voltage(s) |
| Re: Sony KV2150R help please with repairing this set. | [quote:e29861f69a="Eduardo O"]The Stand by/timer LED keeps blinking all time, I have changed the ful |
| Check for supply voltages to the Frame IC. If you don't have a schematic, look up the data sheet fo |
| I would try replacing the capacitors around the sync IC, especially the filter capacitor(s) supplyin |
| [b]SONY TV MDL# KV-27HFR Trinitron - No Picture after 45 Sec | [b:3b1fed15b4]Dear Admin,[/b:3b1fed15b4]
A bundle of thanks for such a wonderful Forum, I appreci |
| Samsung SP42W5HFX | I have a (just over) 2 year old Samsung SP42W5HFX and typically it is now out of warranty. picture i |
| Re: Television repair | [quote:a631a8b3b7="chutch"]I have a Zenith Z32X31D tv which now has no power, about a week prior, th |
| thomson 32sw23u icc17chassis with new transformerkit install | hi all have been following some posts on this model and have replaced a blown fbt with the kit from |
| caution wit this procedure | If your battery is still holding 30min, do not replace it, yet.
If you can't find an exactly same o |
| Newsflash: TV IS FIXED!!! yay!
There was a hairline crack on the HOT emitter pad from changing th |
| Digital TV | I just purchased a SONY DLP HDTV LCD TV.
Plugged in all the wires, etc, the picture is fuzzy, n |
|
|
| :idea: Found the following:
1) C951 = 4.7ufd/250V
2) Suggest changing these caps in standby po |
| Sony KV2150R help please with repairing this set. | The Stand by/timer LED keeps blinking all time, I have changed the full block of power supply from t |
| Re: Code for Becker Mexico Pro MD | [quote:d426097411="marf"]Hello,
after changing the battery my Becker Mexico Pro MD needs the code |
| Audio problem with RCA TV | Hi,
I have a 32" RCA TV which recently started having audio problems after 6 years. The vol |
| DBX SYSTEM IN CASSETTE DECKS | Is there anybody who knows, how the DBX noise reduction system works in cassette decks? I have Techn |
| JVC AV-3551S Any info on this model | Does anyone have any info on this model. Can't find anything online. ESI didn't have anything either |
| Akai model # PT5492S | I have an Akai PT5492S 2002 that wont turn on at first. It makes a Buzzing/sizzleing sound. Also the |
| hitachi c32wd2tn tv fault | this set keeps changing channels and main menu comes up on screen
service mode dosent help would a |
| nec plasma | Hi Bob
This sounds like the unit I have here the PX-42XM1G
it also had no fans but power 170/80 |
| service manual of fuji finepix s 7000 | hello everybody,
i am a phototechnologist, i personally own a fuji finepix s 7000 digital camera, |
| Tecnimagen 14TXS - Can't change sound from 5.5MHz to 6MHz | Hi,
It's been a while since I last did sound conversion on a TV set. Living in Spain, I used to g |
| James,
Looking at the protection ckt in question, you've figured out it's operation. It is based on |
| Sony CDXF 7715X frequency change | Can anyone help out with changing the Mhz tuning to .1Mhz. From USA to UK & provide schematics & |