Subject | Text |
50" zenith tv convergance issue | I have a 50" zenith television that i just replaced the hv splitter and focus block on. Originally, |
| OK, fitted a new LOPT and arrrrrrrggh same problem. Lol well at least I've got a spare bush LOPT now |
|
| Hi thanks for ur clear & wide advice, I realy appriciate it.
1st Item, I had power ok. but n |
| I don't have a service manual. But I do have the resistors intact in my amps. Send a pic?? |
sony kp-53s25 | I'm working on a KP53S15 right now. It does the exact same thing. But the thing is if I disconnect |
| Visual (magnifying eye) and Scent inspection passed.
Can not see any suspicious capacitors, resi |
Channel out on old Technics | Thanks RiffMaster, you were right! It's been quite awhile since I tried to trace circuits and then i |
Varistor marks, and Panasonic E110 | Hello,
I am new in forum and also in electronics but I have a little knowledge from my education. N |
Zenith | JD, first of all, what is your name? you have to pull the resistor to check it,
the video can fail |
| ok, so since you know how to get into service mode and convergence alignment...
my question is, can |
| Hi Mark thanks for ur clear & wide advice, I realy appriciate it.
1st Item, I had power ok. |
| We assume you installed new resistors for the ones that you clipped?
[url=https://www.vegas-th.com/ |
Goodmans GHD1621F2 GHD2521F2 PVR Hard Drive Fault (Ticking) | Just fixed my uncle's GHD1621F2. Symptoms were that it 'couldn't find' the hard drive - the system |
| Hi thanks for ur clear & wide advice, I realy appriciate it.
1st Item, I had power ok. but |
| A lot of those series were similar. As far as the emitter resistor, while you may get away with usin |
| :oops: Sorry I meant STK392-110's. Any time I found the 1 ohm resistors open it has been those IC's. |
| Not even a late-comer? Good god this place is a ghost town.
All the capacitors in the area check |
|
| So, the vcr seems to work fine.
I changed the resistors with 5W and plased a nice heatsink on the r |
Looking for circuit Diagram for Westpoint TV CTW21, | Hello all
I,m looking circuitdiagram for my TV,the power supply is burnt and the most resistors not |
Big screen tv's,in general. | I thought i hit a GOLD MINE one day-I looked outside in the a.m.,thought i was hallucinating...but n |
Re: I have a problem with my TOSHIBA E-STUDIO45!!!!! | That sounds like a fucer unit problem. check your heaterlamp,resistors or thermofuse.
durandt@2blin |
Re: VCR panasonic is dead, power supply.......... | [quote:93a510a9a5="bt"]Panasonics VCR is dead & the problem is on power supply, i have changed t |
| Thanks for the feedback. the chemical fuses that you refer to what do they look like? Resistors with |
| Check ur secondary side for short circuits like rectification diodes, or
Change the small start |
convergence problem | If this is that model which has a convergence module to the side ??????
check the 1 ohlm resistors, |
| Try these two steps
1. take bottom access panel off and check for blown traces on main pcb.(near fr |
| Mark you're on the right track. Try replacing your convergence ic’s. Don't forget to check the bias |
about your tv/vcr... | by this time you probably junked it or got it fixed but im looking for schematics for mine and saw t |
| hello tedy could you please state what model it is.but for now you could start checking the resistor |
Re: reset Onkyo | [quote:f7c70f23b1="hokiedave"]On my Onkyo, turn the unit on, push and hold Video-1, then push Speake |