| Subject | Text |
| Is this really the same convergence fault? | I also have a 42H81 projection TV that has the two vertical lines spaced on the thirds. The lines ar |
| changed out the ic's, put it all back together, and it burnt the resistors again. need some help to |
|
|
| How is the set stuck in standby? Are there any sounds coming from the back of the TV when you switch |
| Gateway VX1120 or Mitsubishi 2060u Service manual? | Hello
Im looking for the service manual for either of those monitors, I search everywhere and I c |
| Denon DRA-685 repaired! | I had bogus voltage readings at CN1 so I snipped out both R105 and R106, which were pinned very clos |
| Which transistor blew? Was it a main output transistor or smaller one in the pre-amp stages? Why did |
| Service Manual for Matsui or Sanyo TV 28M1MKII Please help | My Matsui Chasis 28M1MKII TV got a burnt resistor, the resistors were burnt beyond recognition they |
| Hi Mark,
Thanks for your advice. I checked all the power resistors for the value and replaced the |
| Sony KP-57WV600 Blue CRT driver board | Hello everyone. My dad bought a KP57WV600 tv that had a known convergence issue with the red CRT. |
| hithach 43fdx20b | I have bad resistors on the dp1x convergence pwb board, does anyone have the value of the resistors |