Subject | Text |
Please help ID component in blown Power Supply | Hello,
The power supply in my printer blew out last night. It's pretty obvious from looking what |
| :D [b:3aa7d40ba5][i:3aa7d40ba5]send me an em,[email protected]
also give me full model nr and t |
|
| thats a transistor. if it were me I would look for where it came from.
look for a spot that has a |
AIWA VCD COMPONENT NSX-NK77HR | ANYONE WHO HAS THIS MODEL?NSX or CX-NK77HR VCD COMPONENT. :lol: |
RCA 52" Convergence Issue - Please help. | Hello,
I have a 52" RCA Model p52921, Chassis ptk195mb.
The problem is that the convergence go |
Denon stereo component D-120 / 70: how does it work??? | Hello Friends;
Re: DENON, STEREO COMPONENT D-120 / 70
I bought this radio from someone who w |
| C351 is the component location and any electronics's store has these caps or http://www.matelectroni |
DAEWOO DT4280NH driver board location | can anyone tell me where to locate the driver board on this model? i have taken the back off to reve |
problem with component video | I am getting a red hued screen from the dvd hookup when using the component video. They are Monster |
Front powerswitch pin location on MS-6577 ver 4.1 motherboar | Trying to connect the power switch, reset switch, etc. onto the motherboard, please help |
Re: Likom LD7031LD code of component, please | please the code of this transistor with serigrafia Q107, that is erased, thank you very much to read |
Schematic and Component layout required for Braun 4502 Shave | Folks
I could use a schematic and comp. layout for the Braun 4502. This shaver is termed "flex c |
SONY SAT-HD300 service manual needed or location of one | Hey,
I'm in need of a service manual for this Sony Directv receiver. The one I have does not power |
Unknown component. diode, SOT23 ,CODE WW1 46. | This is diode d39 on Epox motherboad.(probably power supply control signal) Marking is ww1 46. What |
this component needs the code | please the code of this transistor with serigrafia Q107, that is erased, thank you very much to read |
TV Component Required | I want a Fly Back Bs7773 of Supra Color Television (29"). Will Any one can help me. |
Re: Front powerswitch pin location on MS-6577 ver 4.1 mother | [quote="Czan"]Trying to connect the power switch, reset switch, etc. onto the motherboard, |
|
chassis repair or replacement | I have a small car vacuum - Silver Crest ECO- with Circuit board that reads cel-001_cky-2013-1-25, t |
| I am not an expert but to my knowledge you probably won't get a shock from the flyback. The wire and |
Re: Rear Projection won't power on - 50FX30B | [quote:22bb64bd5a="KS"]I have a Hitachi 50FX30B rear projection set that won't power on, no power LE |
SAMSUNG TV MODEL CB5012Z | I NEED:- SAMSUNG TV CB5012Z
1) TV SPECIFICATION
2) LISTS AND TYPES OF COMPONENTS
3) ISOMETRIC DRA |
Re: Pioneer VSX-D606S Service Manual please | [quote:91acd3e948="KMJ129"]Hello,
Does anyone have access to this service manual? My receiver co |
hitachi 50sbx70b convergence chips | I was wondering what resistors need to be replaced when replacing the convergence chips and if by an |
| Can anyone please help me to identify this component?
[img:06a312b818]http://img242.imageshack.us |
| I have got the contact detail for the daewoo service centre which is a unit set up by daewoo to sort |
43pp925 video-inputs-dead | I have a philips rear projection tv model no. 43pp925. All my video inputs are not working in the ma |
Monitor power off. | Problems such as these are normally caused buy poor solder joints and may be worth checking for this |
AIT on an Audi 100(1992 mod) HELP! | I am looking for the location of the AIT sensor in the engine room of an Audi 100 sedan.
PLZ Help! |
Polishing of Silicon wafers | Hi,
I have come across a technological development where we are able to develop nanosilicate |
| Hi
Don’t think about the colors (values) of the resistances, be sure.
The resistor 1 is 560 Ohms & |