| Subject | Text |
| There is no problem using radial mount. As far as the short legs, you need to have a small tip sold |
| Questions on Zenith SJ2773LK | Thanks for the information. BTW, where would the horizontal output transistor & and the power su |
|
|
| sony plasma t.v. fault | Hi. Have a sony plasma 42 inch in for repair. powers up briefly then just as screen lights up it tri |
| soldering iron become black | I have a 25watt weller soldering iron and whenever i am about to solder i always clean the tip but i |
| TOSHIBA CX2886/CX2885C | Thankyou very much for the guidance/tips. According to your tips i have checked/changed the suspecte |
| Help!!! Ford car radio ESRT22DPS | I have problem with my Ford car radio mod.no. ESRT22DPS!
Tape works Normally but radio doesn`t work |
| TV freezes on channels, can't change | I have a 32" Magnavox TV set that has lately been freezing up, not allowing you to switch channels, |
| Sony kv32-cs76 service manual needed | I desperately need the service manual for my Sony kv32-cs76 100hz tv set. I played around with the |
| Re: sony trinitron, falt screen 32inch,where does this cable | [quote:7a6016dabd="CheM"]I got a TV for free, it is brand new, but the screen does not work. I opene |
| Came across these tips for FL1.10 chassis;
[quote:c70eda226f]
Picture height cannot be adjusted |
| super vhs gr-smx730 camcorder | :D hello, it is my first time on the board and I thought I would give it a try. I have been trying |
| As long as the metal tip is still on the end you should be good to go. |
| HELLP ! Open HP Laserjet 4L manual with .rar extension | Hello,
I am a new kid and stumbled across your web site .
My HP Laserjet 4L is on the fritz an |
| Servis manual for TV Nokia 7192. | Hi all,
I would like to repair my TV Nokia 7192. Do you know where to find on internet this servis |
| My panasonic ct-32sx31 turns on and off at whim | I've had this tv for about 2 years and now it has problems turning on or off seemingly at random.
|
| soldering always getting a dull finish, dry ? | hi,
i bought a soldering atation and doing a bit of soldering work on a curcuit board,\
howeve |
| Hi,
Its fortunate u got the player to work fine after some adjustments.
However, its good to |
|
|
| Minnie i don't have a juvenator. i turned down the red bias and the bleeding goes away, but it seem |
| Dead chips in ribbon cables | I got one of these in for repair with the exact same fault. I can confirm that the fault is to do wi |
| FAx Machine ppf 411 | Hi. I have that service manual, but what is your problem with th fax machine? i know very well Phili |
| amplifier mitsubishi model da-ra10 | I need this electronic diagram to repair an amplifier. If possible send me.
tanks a lot
lino |
| 27PT6441/37 Turn ON | I posted last week that I replaced the Thermistor and the set still had the 3-2-1 code and did not t |
| I do get the same failure. I tried by replacing the tuner twice but apparently nothing change.
Do |
| Projection TV turns itself off | I have a weird projection TV problem. This is a 55-in Pioneer, which turns off by itself. This start |
| Compaq FS740 | Hi,
I am loking for a schematic / repair info for a FS740 monitor too. Trying to repair one which |
| hi all,
did someone find some data about A60/70?
could you finally repair?
i have same problem wi |
| I have repaired hundreds of the ford radios, i repair car audio for a living, you need a soldering i |
| Aiwa NSX-S555 | I have problems with this mini component, the tuner works fine FM/AM. however with the cd player and |
| Silvercrest CT2116 | Just an update on this: It seems that this uses an almost identical chassis to the Vestel 11AK30 cha |
| Intelligent power module (IPM) repair- Hitachi 42" Plas | Anybody ever try and repair one of these ? I've got a YPPD J007C that has a blown component.
Its |
