| Subject | Text |
| I do not agree with Dfarhen, if you do not know what you are doing or do not have a tester for the c |
| OK
No idea what was wrong, ALL IS FINE AND WORKS AGAIN!
The problem was one of the pico fuses.
|
|
|
| How would i go about getting their service manual? I have already emailed them asking them how to op |
| Re: The "hot side" | I've seen a similar effect twice. One tech had cut off ground pin of scope's power cord and had plug |
| Never heard of anyone doing this before. Just stick the module in. No programming should be requir |
| ok, so since you know how to get into service mode and convergence alignment...
my question is, can |
| 1) Resolder all the output transistors solder joints and any other intermediate transistor stages th |
| RF connector for tuner.
Reattach the original "stub" to the tuner being very careful ab |
| Re: Remove Cover | [quote:4ad1016cea="starchaser09"]Hi all,
My question to anyone is how to remove the cover to get |
| Analogue radio repairs | Radios for hard to fix radios
GP300:
Fault…. Doesn't turn On (Dead radio)
1/Check Fuses
2/Resold |
| TV database | Hi,
Does anyone know where to download a nice database, where you can save your TV faults.
So |
| problem solved! | A friend of mine borrowed me a HDD. After mounting it, I noticed the problem couldnt be a faulty HDD |
| If the channel selector uses touch buttons, then a common cause for resetting to a specific channel |
| N3251W Randomly Shuts Off/On | Did you check for poor capacitors in the power supply? The top of a capacitor should be perfectly f |
| well, I have to agree with Larry, on a lot of his points.
Just so you can get an idea, im in the |
| Hi Ed,
I had a similar situation with a '70's Pioneer amp using similar NEC transistors. Over her |
| Well.... | The NEC PX-42VP4g is similar, if not exactly the same as the Pioneer PDP-424MX. There is a service d |
|
|
| screen lcd alpine on car bmw x5 | Hello,
i'm looking for the electronic schematic on pcb inverter for an alpine car systeme mounting |
| Usually those connectors 'come loose' from too much force being brought to bear.
Is there a lead re |
| Philips big screen has two faint colors vert. on left side | My Philips has two faint color lines (red & green)from top to bottom on left of screen. They are |
| KEF PSW 2500 relay buzz and audio outout buzz | Have just repaired a similar problem with a KEF 2500 - relay was chattering at 50 Hz rate, buzz in s |
| I'm lucky that repair and maintain wide variety of equipment including pneumatics - I also get to w |
| CN701 Wire Colors (left to right, left being closest to PCB mounting screw)
Black, Brown, Red, Or |
| Toroidal Transformers - Hilltech Sales Corporation | Improve your design by using a Toroidal Transformer for Higher Efficiency, Lower Weight, Low No-Load |
| I had the same problem and I solved in this way (cut & paste from nl.hobby.video newsgroup messa |
| I think that there is not much to do to get the problem solved unless the site's administrator kan g |
| INSIGNIA 32" NS-LDVD32Q-10A | Everything works good except the cable connector is loose. I took the back off of the set and found |
| Re: C5929 HOT substitute | [quote:b1f0082f54="dolescle"]Anybody know a good substitute for C5929 I can't find any datasheet for |
| Proline 1485R TV | Can anyone tell me how to extract the PCB from its mounting slot so that I can check the power switc |
| I assume the 2 rings your talking about are at the base of each crt?
as in, above where the circuit |