Text preview for : Panel_BOE_HT190WG3-101_0_[DS].pdf part of . Various Panel BOE HT190WG3-101 0 [DS] . Various LCD Panels Panel_BOE_HT190WG3-101_0_[DS].pdf
Back to : Panel_BOE_HT190WG3-101_0_ | Home
Global LCD Panel Exchange Center www.panelook.com
PROPRIETARY NOTE
THIS SPECIFICATION IS THE PROPERTY OF BOE OT AND SHALL NOT BE
REPRODUCED OR COPIED WITHOUT THE WRITTEN PERMISSION OF BOE OT AND
MUST BE RETURNED TO BOE OT UPON ITS REQUEST
TITLE : HT190WG3-101
Product Specification
Rev. 0
BEIJING BOE OPTOELECTRONICS TECHNOLOGY
SPEC. NUMBER PRODUCT GROUP Rev. ISSUE DATE PAGE
TFT-LCD O 2010.11.16. OF 29
B2006-5006-O (1/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT O NOV. 16. 10'
REVISION HISTORY
REV. ECN No. DESCRIPTION OF CHANGES DATE PREPARED
0 Initial Release NOV. 16. 10' Zhou Jiming
SPEC. NUMBER SPEC. TITLE PAGE
HT190WG3-101-1940 & 1240 Product Specification OF 29
B2006-5006-O (2/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT O NOV. 16. 10'
Contents
C t t
No. Item Page
1.0 General Description 4
2.0 Absolute Maximum Ratings 6
3.0 Electrical specifications 7
4.0 Optical specifications 8
5.0 Interface Connection 10
6.0 Signal Timing Specifications 14
7.0
70 Signal Timing waveforms of Interface Signal 16
8.0 Input Signals, Display Colors & Gray Scale of Colors 18
9.0 Power Sequence 19
10.0 Mechanical Characteristics 20
11.0 Reliability Test 21
12.0 Handling & Cautions 22
13.0 Product Serial Number 23
14.0 Packing 24
15.0 Appendix 26
SPEC. NUMBER SPEC. TITLE PAGE
HT190WG3-101-1940&1240 Product Specification OF 29
B2006-5006-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT O NOV. 16. 10'
1.0 GENERAL DESCRIPTION
1.1 Introduction
HT190WG3-101 is a color active matrix TFT LCD module using amorphous silicon TFT's
(Thin Film Transistors) as an active switching devices. This module has a 19.0 inch
diagonally measured active area with WXGA+ resolutions (1440 horizontal by 900 vertical
pixel array). Each pixel is divided into RED, GREEN, BLUE dots which are arranged in
vertical stripe and this module can display 16.7M colors. The TFT-LCD panel used for this
module is adapted for a low reflection and higher color type.
CN21
LVDS LVDS Rx Source Driver
Input +
Signal T/CON
+
Connector (CN
Gate Driver
RSDS Tx
TFT LCD Panel
1440 900
VDD DC/DC
1 Gamma
)
Vcom
CN22
1.2 Features
z LVDS Interface with 2 pixel / clock
z High-speed response
z Low power consumption
z 6-bit (Hi-FRC) color depth, display 16. 7M colors
z Incorporated edge type back-light (Two lamps)
z High luminance and contrast ratio, low reflection and wide viewing angle
z DE (Data Enable) only
z RoHS Compliant
z TCO'5.0 Compliant
SPEC. NUMBER SPEC. TITLE PAGE
HT190WG3-101-1940&1240 Product Specification OF 29
B2006-5006-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT O NOV. 16. 10'
1.3 Application
z Desktop Type of PC & Workstation Use
z Slim-Size Display for Stand-alone Monitor
z Display Terminals for Control System
z Monitors for Process Controller
1.4 General Specification
The followings are general specifications at the model HT190WG3-100.
1.
Parameter Specification Unit Remarks
Active area 408.24(H) 255.15(V) mm
Number of pixels 1440(H) 900(V) pixels
Pixel pitch 0.2835(H) 0.2835(V) mm
Pixel arrangement RGB Vertical stripe
Display colors 16.7M colors
Display mode Normally White
Dimensional outline 428.0(H) 278.0(V) 17.0(D) typ. mm
Weight 1980 (Typ.) g
Surface Treatment Haze 25%, 3H
Back-light Top/Bottom edge side, 2-CCFL type
SPEC. NUMBER SPEC. TITLE PAGE
HT190WG3-101-1940&1240 Product Specification OF 29
B2006-5006-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT O NOV. 16. 10'
2.0 ABSOLUTE MAXIMUM RATINGS
The f ll i i l hi h
Th followings are maximum values which, if exceed, may cause faulty operation or
d f lt ti
damage to the unit. The operational and non-operational maximum voltage and current
values are listed in Table 2.
< Table 2. Absolute Maximum Ratings> [VSS=GND=0V]
Symbol Min. Max. Unit Remarks
Parameter
Power Supply Voltage VDD VSS-0.5 5.5 V
Ta = 25
Logic Supply Voltage VIN VSS-0.3 VDD+0.3 V
Back-light Lamp Current IBL 3 8 mA
Back-light Lamp frequency FL 40 80 kHz
Operating Temperature TOP 0 +50 1)
Storage Temperature TST -20 +60 1)
Note : 1) Temperature and relative humidity range are shown in the figure below.
Wet bulb temperature should be 39 OC max. and no condensation of water.
SPEC. NUMBER SPEC. TITLE PAGE
HT190WG3-101-1940&1240 Product Specification OF 29
B2006-5006-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT O NOV. 16. 10'
3.0 ELECTRICAL SPECIFICATIONS
3.1Electrical Specifications
< Table 3 Electrical specifications >
bl 3. l i l ifi i [Ta 2
[ =25 2 ]
Parameter Min. Typ. Max. Unit Remarks
Power Supply Voltage VDD 4.5 5.0 5.5 V
Note1
Power Supply Current IDD - 800 1000 mA
In-Rush Current IRUSH - 2.0 3.0 A Note 2
Permissible Input Ripple Voltage VRF - - 100 mV VDD = 5.0V
High Level Differential Input
VIH - - +100 mV
Threshold Voltage
Vcm = 1.2V typ.
Low Level Differential Input
VIL -100 - - mV
Threshold Voltage
LVDS Differential Input Voltage |VID| 200 - 600 mV
VIH = 100mV
Common mode Voltage
LVDS C d V lt VCM 10
1.0 1.2
12 1.5
15 V
VIL = -100mV
Back-light Lamp Voltage VBL - 712 880 Vrms
Back-light Lamp Current IBL 3.0 7.5 8.0 mArms
Back-light Lamp operating Frequency FL 40 - 80 KHz Note 3
- - 1400 Vrms 25 , Note 4
Lamp Start Voltage
- - 1800 Vrms 0 , Note 4
Lamp Life 50,000 - - Hrs IBL= 7.5 mA
PD - 4.00 5.00 W
Power Consumption PBL - 10.68 14.0 W IBL=7.5 mA, Note 5
Ptotal - 14.68 19.00 W
Notes : 1. The supply voltage is measured and specified at the interface connector of LCM.
The current draw and power consumption specified is for VDD=5.0V, Frame rate=75Hz and
Clock frequency = 56.3MHz. Test Pattern of power supply current
a) Typ : Color Bar pattern
b) Max : Skip Sub Pixel Pattern
2. Duration of rush current is about 2 ms and rising time of VDD is 520 s 20 %
3. The lamp frequency should be selected as different as possible from the horizontal
h f di h i id i f hi h li fl h di l
synchronous frequency and its harmonics to avoid interference, which may cause line flow on the display
4. The voltage above this value should be applied to the lamps for more than 1 second to start-up. Otherwise the
lamps may not be turned on.
5. Calculated value for reference (VBL IBL) 2 excluding inverter loss.
SPEC. NUMBER SPEC. TITLE PAGE
HT190WG3-101-1940&1240 Product Specification OF 29
B2006-5006-O (3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT O NOV. 16. 10'
4.0 OPTICAL SPECIFICATION
4.1 Overview
41O i
The test of Optical specifications shall be measured in a dark room (ambient luminance d 1 lux and temperature =
25r2 ) with the equipment of Luminance meter system (Goniometer system and TOPCONE BM-5) and test unit shall
be located at an approximate distance 50cm from the LCD surface at a viewing angle of and equal to 0q. We refer to