Text preview for : Panel_BOE_HM200WD1-100_0_[DS].pdf part of . Various Panel BOE HM200WD1-100 0 [DS] . Various LCD Panels Panel_BOE_HM200WD1-100_0_[DS].pdf
Back to : Panel_BOE_HM200WD1-100_0_ | Home
Global LCD Panel Exchange Center www.panelook.com
PROPRIETARY NOTE
THIS SPECIFICATION IS THE PROPERTY OF BOE HF AND SHALL NOT BE
REPRODUCED OR COPIED WITHOUT THE WRITTEN PERMISSION OF BOE HF AND
MUST BE RETURNED TO BOE HF UPON ITS REQUEST
SPEC. NUMBER PRODUCT GROUP ISSUE DATE PAGE
S8-64-6A-072 TFT-LCD Rev. 0
2012.02.02 OF 29
TITLE : B3 HM200WD1-100
Product Specification
Rev. 0
HEFEI BOE OPTOELECTRONICS TECHNOLOGY
R2010-6053-O(1/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT 0 2012.02.02
SPEC. NUMBER SPEC. TITLE PAGE
S8-64-6A-072 B3 HM200WD1-100 Product Specification_ Rev. 0 OF 29
REVISION HISTORY
REV. ECN No. DESCRIPTION OF CHANGES DATE PREPARED
0 Initial Release 2012.02.02
R2010-6053-O(2/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT 0 2012.02.02
SPEC. NUMBER SPEC. TITLE PAGE
S8-64-6A-072 B3 HM200WD1-100 Product Specification_ Rev. 0 OF29
Contents
No. Item Page
1.0 General Description 4
2.0 Absolute Maximum Ratings 6
3.0 Electrical Specifications 7
4.0 Optical Specifications 8
5.0 Interface Connection 10
6.0 Signal Timing Specifications 13
7.0 Signal Timing Waveforms of Interface Signal 15
8.0 Input Signals, Display Colors & Gray Scale of Colors 17
9.0 Power Sequence 18
10.0 Mechanical Characteristics 19
11.0 Reliability Test 20
12.0 Handling& Cautions 21
13.0 Product Serial Number 22
14.0 Packing 23
15.0 Appendix 25
R2010-6053-O(3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT 0 2012.02.02
SPEC. NUMBER SPEC. TITLE PAGE
S8-64-6A-072 B3 HM200WD1-100 Product Specification_ Rev. 0 OF29
1.0 GENERAL DESCRIPTION
1.1 Introduction
HM200WD1-100 is a color active matrix TFT LCD module using amorphous silicon TFT's
(Thin Film Transistors) as an active switching devices. This module has a 20 inch diagonally
measured active area with WXGA resolutions (1600 horizontal by 900 vertical pixel array).
Each pixel is divided into RED, GREEN, BLUE dots which are arranged in vertical stripe and
this module can display 16.7M colors. The TFT-LCD panel used for this module is adapted for
a low reflection and higher color type.
LVDS LVDS Rx Source Driver
Input +
Signal T/CON
+
Connector (CN
Mini LVDS Tx
Gate Driver
TFT LCD Panel
1600 900
VDD DC/DC
1 Gamma
)
Vcom
1.2 Features
z LVDS Interface with 2 pixel / clock
z High-speed response
z Low power consumption
z 6-bit (Hi-FRC) color depth, display 16. 7M colors
z Incorporated edge type back-light (One Light Bar)
z High luminance and contrast ratio, low reflection and wide viewing angle
z DE (Data Enable) only
z RoHS / TCO 5.0 Compliant
R2010-6053-O(3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT 0 2012.02.02
SPEC. NUMBER SPEC. TITLE PAGE
S8-64-6A-072 B3 HM200WD1-100 Product Specification_ Rev. 0 OF29
1.3 Application
z Desktop Type of PC & Workstation Use
z Slim-Size Display for Stand-alone Monitor
z Display Terminals for Control System
z Monitors for Process Controller
1.4 General Specification
The followings are general specifications at the model HM200WD1-100.
Parameter Specification Unit Remarks
Active area 442.8(H) 249.075(V) mm
Number of pixels 1600(H) 900(V) pixels
Pixel pitch 0.27675(H) 0.27675(V) mm
Pixel arrangement RGB Vertical stripe
Display colors 16.7M colors
Display mode Normally White
Dimensional outline 462.8(H) 272(V) 10.2(D) typ. mm
Weight 1700 (typ.) g
Surface Treatment Haze 25%, 3H
Back-light Right Edge Side, 1- LED Light bar EA
R2010-6053-O(3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT 0 2012.02.02
SPEC. NUMBER SPEC. TITLE PAGE
S8-64-6A-072 B3 HM200WD1-100 Product Specification_ Rev. 0 OF29
2.0 ABSOLUTE MAXIMUM RATINGS
The followings are maximum values which, if exceed, may cause faulty operation or
damage to the unit. The operational and non-operational maximum voltage and current
values are listed in Table 2.
< Table 2. Absolute Maximum Ratings> [VSS=GND=0V]
Symbol Min. Max. Unit Remarks
Parameter
Power Supply Voltage VDD -0.5 5.5 V
Ta = 25
Logic Supply Voltage VIN VSS-0.3 VDD+0.3 V
LED Channel Current IBL - 80 mA
Operating Temperature TOP 0 +50 1)
Storage Temperature TST -20 +60 1)
Note : 1) Temperature and relative humidity range are shown in the figure below.
Wet bulb temperature should be 39 OC max. and no condensation of water.
R2010-6053-O(3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT 0 2012.02.02
SPEC. NUMBER SPEC. TITLE PAGE
S8-64-6A-072 B3 HM200WD1-100 Product Specification_ Rev. 0 OF29
3.0 ELECTRICAL SPECIFICATIONS
3.1Electrical Specifications
< Table 3. Electrical specifications >
[Ta =25 2 ]
Parameter Min. Typ. Max. Unit Remarks
Power Supply Voltage VDD 4.5 5.0 5.5 V
Note1
Power Supply Current IDD - 920 1200 mA
In-Rush Current IRUSH - 2.0 4.0 A Note 2
Permissible Input Ripple Voltage VRF - - 100 mV VDD = 5.0V
High Level Differential Input
VIH - - +100 mV
Threshold Voltage
Low Level Differential Input
VIL -100 - - mV
Threshold Voltage
Differential input voltage |VID | 200 - 600 mV
VIH=100mV,
Differential input common mode voltage Vcm 1.0 1.2 1.5
VIL=-100mV
LED Channel Voltage VL 37.7 41.6 46.8 V
LED Channel Current IL 57 60 63 mA
LED Lifetime 30,000 - - Hrs I
PD - 4.6 - W
Power Consumption PBL 9.05 9.98 11.23 W IL=60 mA, Note 5
Ptotal - 14.58 - W
Notes : 1. The supply voltage is measured and specified at the interface connector of LCM.
The current draw and power consumption specified is for VDD=5.0V, Frame rate=75Hz and
Clock frequency = 95MHz. Test Pattern of power supply current
a) Typ : Color Bar pattern
b) Max : Skip Sub Pixel Pattern
2. Duration of rush current is about 2 ms and rising time of VDD is 520 s 20 %
3. The lamp frequency should be selected as different as possible from the horizontal
synchronous frequency and its harmonics to avoid interference, which may cause line flow on the display
4. The voltage above this value should be applied to the lamps for more than 1 second to start-up. Otherwise the
lamps may not be turned on.
5. Calculated value for reference (VL IL) 4(channel) excluding driver loss. (LED Light bar: 13S4P)
R2010-6053-O(3/3) A4(210 X 297)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
PRODUCT GROUP REV ISSUE DATE
TFT- LCD PRODUCT 0 2012.02.02
SPEC. NUMBER SPEC. TITLE PAGE
S8-64-6A-072 B3 HM200WD1-100 Product Specification_ Rev. 0 OF29
4.0 OPTICAL SPECIFICATION
4.1 Overview
The test of Optical specifications shall be measured in a dark room (ambient luminance d 1 lux and temperature =
25r2 ) with the equipment of Luminance meter system (Goniometer system and TOPCONE BM-5) and test unit shall
be located at an approximate distance 50cm from the LCD surface at a viewing angle of and equal to 0q. We refer to