Make | Model | Problem | Solution | Date |
| | | |
Found: 8
|
Bush | BM6514 Ranger 2 | Hum bar & picture distorted. | 2x Diodes on right hand side from back ( BY133 type ) | 14-09-04 |
Philips | 28PW6515/05 | NO raster EHT ok. Int trips if screen volts turned up | D6832 O/C on CRT IN4148 | 14-09-04 |
Philips | 28PW6515/05 | R/C inop | Dry joints on IC7064 solder with care dual layered PCB. | 14-09-04 |
Philips | 32pw6515 | hi my philips tv (32pw6515) is now stuck in standby (red led on) and no responce from either the on-board controls or remote?
| the fault on your philips tv is probably ic7064. also known as the painter ic, on the small signal board, this ic seems to be responsible for over 90% of faults on this chassis. it is a 100 pin surface mount device. i would not recommend trying to replace it unless you have a good amount of experience at soldering very small devices as it is not much bigger than a stamp, you will also need to reprogramme the eeprom ic with the options and geometry settings after replacement, i have done more than 30 and it takes me upto 2 hours | 31-10-05 |
Philips | 32pw6515/05 | after set is on for 5 minutes there is no response from remote handset
or controls on tv | Ic 7064 on small signal board.
| 08-08-05 |
Philips | 32PW6515/05 SA10E | Hum from front speaker | Remove link 9710 & connect link from 9710 (C2702 end) to link 9278 | 14-09-04 |
Philips | A10 28PW6515/05 | Reverts to st/by aft several hours until sw off at mains & re-started | IC7064 micro | 14-09-04 |
Philips | A10E 28PW6515/05 | Random variation of width/height with pic jumping | Painter micro chip faulty | 14-09-04 |