Make | Model | Problem | Solution | Date |
| | | |
Found: 7
|
Mitsubishi | CT25AV1BD | Field collapse | D561 s/c on E/W IC & R516 o/c | 14-09-04 |
Mitsubishi | CT25AV1BD EE3 | Blank raster with no sound or osd | No 8v - fit kit 8vREG-KIT from SEME | 14-09-04 |
Mitsubishi | CT25AV1BD EE3 | Dead - Green LED lit | change C702 to 10uf & C955 to 3300uf also change R702 R213 & R214 from 220R to 1k & reset eeprom | 14-09-04 |
Mitsubishi | CT25AV1BD EE3 | Dead - LOPTr s/c | TEA2031A E/W chip IC551 faulty, R510 100R 2w overheating due to L501 6800uH shorted turns | 14-09-04 |
Mitsubishi | CT25AV1BDS | Service mode & EEPROM settings | Switch on with mains switch and press service microswitch, select button 9 on the remote within 5secs. You will now be in the service mode. Use the buttons on the remote control for the following adjustments:
* to toggle between adjustment displays
1 cancel; 2 increase adjustment code; 4 decrease data value; 6 increase data value; 8 decrease adjustment code; 9 adjustment mode on; 0 write to the eeprom( press this to write your changes to the eeprom)
Here are the options-
TUN 0; SAT 1; AUD 10; ATS 1; STD 1; SYS 1; AV1 2; EEX -; SPK 1; EEP -; ABG 02; A1 02;AL 00; ADK 15; MNP 70; TXT -; FFT 1; VOL 74;HYP 1; SCP 20; FMP 23.
not all options appear to be available to some models. Adjustments in the VCJ mode will be in default mode and it will be necessary to observe display in order to set-up width height ew etc. | 14-09-04 |
Mitsubishi | CT25AV1BDS EE3 | Int blows LOPTr at sw on from cold & lack of height/int contrast from cold | C956 6.3V 470uF in 5V supply. | 14-09-04 |
Mitsubishi | EE3 CT25AV1BDS | Herringbone pattern, flashing lines etc with no pic for 5 minutes. Picture then slowly appears | C956 470uF 6.3V | 14-09-04 |