Make | Model | Problem | Solution | Date |
| | | |
Found: 8
|
NordMende | F10 Chassis | Field centring poor | CL28 1000µ, RL52 15R | 14-09-04 |
Panasonic | Euro 5 TX33PF10 | Low unadjustable sound on AV | Perform 'self check' by pressing "-/V" button on set & "status" button on handset together. To exit switch off with power button | 14-09-04 |
Panasonic | Euro 5 TX33PF10 | Sound but no pic | Perform 'self check' by pressing "-/V" button on set & "status" button on handset together. To exit switch off with power button | 14-09-04 |
Panasonic | Euro 5L TX36PF10 | Tries to start up but shuts down into standby within
seconds of pressing the power switch. | Replace the 2SC2925STA line driver transistor (Q502) which had an open circuit b-e junction and also replace the X24C0501UA EAROM chip (IC1102) which had become corrupted. | 14-09-04 |
Panasonic | EURO5 TX36PF10 | will not tune in any stations after auto-tune | replace IC1101 SDA5450C481 on E board | 14-09-04 |
Panasonic | TX29GF10 | Panasonic TX29GF10 29" won't start. I can hear a clicking sound when I try to switch it on by remote or otherwise. | First try to find out if you've got the correct voltage's on the secundaire site of the power suply.
Sometimes e.g. there is a short-circuit in the deflection circuit, and the power suply goes into a "safe-mode".
Also check the status of the "stand by"-led.
| 29-06-05 |
Panasonic | TX32PF10 Euro 5 | Sound disappeared then also pic aft sw off | All volts rails ok -Replace faulty EAROM (IC1102) (X24C0503TA) | 14-09-04 |
Schneider | F10 | LED blinking 3 times & no power | BU808DFI (HOT)blown, replacement restored pic but shifted to right - C125 4µ7 faulty | 14-09-04 |