Make | Model | Problem | Solution | Date |
| | | |
Found: 13
|
Goodmans | GVT66W1 11AK19 | Lack of width & E/W faulty | R629 2R7 1/3w safety res o/c | 14-09-04 |
Goodmans | GVT66W1 11AK19 | To enter service mode | Call up install menu then pres 4, 7, 2 & 5 in order | 14-09-04 |
Goodmans | TVC146TWS Pan TX14GV1 | Dead - relay slowly clicking | standby I.C. I807 a TOP210PFI and C840 47mfd | 14-09-04 |
Panasonic | TX-21GV1C | No picture, no sound, flickering light on two indicators("Power"-green, "Timer Rec"-Orange"), continous Clicking sound.
The problem occured after a short power cut in my house.
| replace c840 in psu 47mfd 25v | 03-01-06 |
Panasonic | TX14GV1 | Dead with mains relay clicking continuously. | Replace 47uF 25V (C840) in standby supply circuit. | 14-09-04 |
Panasonic | TX14GV1 | No pic - int comes on with bang - sound ok | Invisible crack in print at LOPTr coll | 14-09-04 |
Panasonic | TX14GV1 | text lines on the top | EAROM IC703 FAULTY, PART NO. AT24C0810PC | 14-09-04 |
Panasonic | TX14GV1 Daewoo CP421 | Relay clicking No sound or vision | Check C840 47mfd and I807 TOP210PFI | 14-09-04 |
Panasonic | TX14GV1 Z421V | Int reverts to st/by | Replace TOP210PFI standby control chip (I807) and I.R. Receiver module (IQ01 | 14-09-04 |
Panasonic | TX14GV1L | Locking up | The official remedy for this fault from Panasonic is to replace both the main microprocessor (I701) and the EAROM (I703). The new part numbers for these are:-
I701 MS5457CU1, I703 X24C-14GV1 | 14-09-04 |
|
Panasonic | TX21GV1 Z421V | No R/C aft 2 hrs | Replace IR sensor KRT30 from type 36 to 3F | 14-09-04 |
Panasonic | Z421V TX21GV1 | Flyback lines at top - Txt OK | Remove by going thro' self test proc - press vol down on set & status button on hset | 14-09-04 |
Panasonic | Z421V TX21GV1 | Int switches off & on | IC1807 TOP210 chopper chip | 14-09-04 |