| Make | Model | Problem | Solution | Date |
| | | |
| Found: 10
|
| Crown | CRP14 Matsui 2096 | Child Lock removal | Connect a tact switch between pin 4 & 17 of IC1 (in r/c) . When TV is sw on via R/C & a chan is selected that has a PASS code no. (child lock) will allow access approx 1 sec after pressing the tact switch once. The pass channel will clear & pic will return. To remove child lock permanently press tact switch again a message "PASS CLEAR" will appear on screen | 14-09-04 |
| Goodmans | 215N T2172TUSU Comet | dead with ticking noise from loud speakers | C811& C813 both 100uF 16v, C812 1uF 50v
All read very low, in power supply circuit | 14-09-04 |
| Grundig | Super color 8472/8672/8272/8872/9272 | R621(6,2ohms) smokes immediately after switch-on. | Replace thyristor Ty503 type17127 | 14-09-04 |
| Grundig | Super color 8472/8672/8272/8872/9272 | R621(6,2ohms) smokes immediately after switch-on. | Replace thyristor Ty503 type17127 | 14-09-04 |
| Grundig | Super color 8472/8672/8272/8872/9272 | Won't search. | Pin 5 of syntheseizer module, should have 3,5 volts. If not, change R4111 (1,8 volts). | 14-09-04 |
| Grundig | Super Color 8615/8415/8215/8115 | Won't start, no EHT present. | Di518 Sced. It's located behind the large 15uF nonpolar cap.(C532) | 14-09-04 |
| Hitachi | CP2514TE Issue 7C | Service mode access | If the set has 3 pins close to the earom 24c04 then short pins 1 & 2 or 2&3 . | 14-09-04 |
| JMBC | 2099TX Matsui TVR180 | St/by only | syscon/timer/servo IC1006 OEC0078C using the sub-panel to get it out
of S/by and then corrected incorrect Hex values. (Or get preprog 24C08 from Grandata) | 14-09-04 |
| Samsung | LE32A456C2D PSU board: BN44-00214A | ot coming out of standby or shutting down. | Check solder joints on T0-220 MOSFET QB802 on the power supply board.
| 11-10-12 |
| Sony | FE1 KV25KSU | FRAME IC HOT LINES ON SCREEN | REPLACE C506 0.01MFD | 14-09-04 |