| Make | Model | Problem | Solution | Date |
| | | |
| Found: 27
|
| Goodmans | SD1800 | CHILDLOCK | PRESS "STANDBY" AND "SYSTEM" TOGETHER | 14-09-04 |
| JVC | AV25SD4EK | Burring noise for first 20 mins | C409 100µ 65v on Dolby PCB | 14-09-04 |
| JVC | AV28SD4EK | Brief burst of power then dead | LOPTx | 14-09-04 |
| JVC | AV28SD4EK | Dead, R526 burnt out C468/469 exploded | Replaced D521 BY228, D523 BYW95B R526, 39R D525 27v zener . | 14-09-04 |
| JVC | AV28SD4EK | Service mode entering | press "DISPLAY" and "VSN Standard" together & note settings While still in the service mode, press "Display" and "VSN Standard" again to enter the system constants menu.
Now write down all the settings in the system constants menu. Press EXIT twice to return to the normal screen.
Switch the set off and replace the EEPROMs with a new ones. Then go back to the service/system menu and enter all the data what you have written down. After all the items have been set, press "OK" to store.zbv | 14-09-04 |
| JVC | AV28SD4EK | Shuts down aft few secs | EEPROM faulty | 14-09-04 |
| JVC | AV28SD4EK MXIV | No sound and all programs show the same channel | Check the data lines on pins 14 and 13 of the connector CNO13 on the sound subboard. If they are low, disconnect the lines one by one from all the chips until the correct level is restored (about 4 V p-p). Also check IC001 5V regulator for DJs, as this could be the culprit. In this case all 3 chips on the sound board had leaky data line inputs: | 14-09-04 |
| JVC | AVS25SD4EK | Comes on briefly to show good pic in EXT3 then reverts to st/by | Possible EEPROM corruption - press "I" and "Audio Mute" simultaneously on handset. This will put it into test mode. Another quirk of some EEPROM problems is that the set will often switch to standby when going into or out of Service Mode or when pressing "VSM Reset". | 14-09-04 |
| Mitsubishi | CT28AV1BSD | Dead | C955 3300µ 16v & reprog EEPROM | 14-09-04 |
| Pioneer | SD21AV1 | blank screen - purple at right | ripple on 12v line cured by replacing C522 100µ, C525 10µ. TDA5930 u/s | 14-09-04 |
|
|
| Pioneer | SD26 | DEAD SOMETIMES SQUEALS OR TICKS | C852 2200uF | 14-09-04 |
| Pioneer | SD26 | Dead with squealing from psu | C852 2200µ | 14-09-04 |
| Pioneer | SD28AV1 | Bright raster with flyback lines. | T1043 ( BC858B ) , T1044 ( BC871 ) , R1043 ( 1k ) | 14-09-04 |
| Pioneer | SD28AV1 | Dead - 2amp fuse blown. | FH1701 ( IN4007 ) | 14-09-04 |
| Pioneer | SD28AV1 | Dead - No HT o/p from psu when connected | IC401 fop chip TDA3654 s/c 26v supply | 14-09-04 |
| Pioneer | SD28AV1 | Dead. | TR501 , T501 ( S2000AF ) , IC521 ( uA7812 ) , IC3501 ( TDA1521 ) , FH1701 ( 1N4007 ) | 14-09-04 |
| Pioneer | SD28AV1 | Dull picture with flyback lines. | CRT faulty. | 14-09-04 |
| Pioneer | SD28AV1 | Frame cramping. | IC402 ( TDA3654 ) | 14-09-04 |
| Pioneer | SD28AV1 | No B-Y. | IC950 ( TDA4680 ) | 14-09-04 |
| Pioneer | SD28AV1 | No colour. | IC1452 ( SDA3526/2 ) | 14-09-04 |
| Pioneer | SD28AV1 | Pic displaced 3" to left | C516 470pF 1600v | 14-09-04 |
| Pioneer | SD28AV1 | Picture displaced to RHS. | C502 ( 7.5nf ) | 14-09-04 |
| Pioneer | SD28AV1 | Small raster - low 155v line. | IC723 ( L7808CX ) | 14-09-04 |
| Pioneer | SD28AV1 | St/by only - led flickers | 5v from 7805 IC722 reg varies - Micro IC1415 pin 27 s/c | 14-09-04 |
| Sharp | 66CSD8H | Service mode entering | PRESS CH+ AND VOL- AND SWITCH ON | 14-09-04 |
| Sharp | DA100 66ESD7H | Field collapse - sound ok | 13v supply to IC501 FOP chip low at 8v. C501 470µ 25v leaky | 14-09-04 |
| Toshiba | SD22VB | Dead aft thunderstorm | Q501 (STP5NC50FP), R506 (470k, 1/4W), R516 (0R22 1/2w), D510 (22VZener?), D529 (SB290S) fitted a IN4007 | 14-09-04 |