Philips Senseo HD7810/10 free download

File name HD781010.pdf

Coffee Maker Senseo HD7810/10 Philips Domestic Appliances and Personal Care Service Manual PRODUCT INFORMATION - This product meets the requirements regarding interference suppression on radio and TV. - After the product has been repaired, it should function properly and has to meet the safety requirements as officially laid down at this moment. TECHNICAL INFORMATION Voltage Frequency Power consumption Standby power consumption Contents reservoir Colour setting : : : : : : 220 - 230 V 50 Hz 1450 W 0.002 kWh 755 cc White / Vapour dusk Waterlevel Sensor Temp. Sensor L Pump M CONTROL PCB Automatic thermostat Boiler N Push buttons Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification 04/02 DISASSEMBLY- AND RE-ASSEMBLY ADVISE Disassembly information To remove the brew chamber lid cover (item 8 exploded view) handle as follows: - Place the screwdriver on the positions (see picture 1) and lift the cover over the snap locks on both positions. HD7810/10 Removing Brew chamber head (item 1 exploded view) handle as follows: - Back cover and 3-way valve must be disassembled! - Place the appliance such a way that you are looking at the boiler. - First remove the boiler from the snap lock position of the brew chamber. (there were the boiler is fixed to the brew chamber) - To do so use a screwdriver and bend slightly the both ribs to the outer side and pull the boiler out of the fixation point. - To remove the brew chamber, use your both thumbs (see picture 3) and push strongly with a little distortion (rotation) until the brew chamber comes loose. picture 1 - The cover lid can now be lifted up a little and to remove the complete cover including lever and push rod (items 9 and 10) squeeze strongly with two fingers both legs of the push rod (see picture 2) to each other, so that the two pins will get out of the hinge position on the brew chamber. picture 3 picture 2 - Reassemble follow above steps backwards. To reach the components placed on the base handle as follows: - First remove back cover, brew chamber and 3-way valve. - Remove both Torx T15 screws see exploded view in the near of position A. - Bend the 2 click snap locks with a screwdriver (see base), and the housing can now be removed. - To remove the rest of the housing unlock the last 4 snap locks at the base and gently pull of the front cover. - To reassemble follow above steps backwards. REPAIR INSTRUCTION Descaling Regular descaling will prolong the life of your appliance and will guarantee optimal brewing results for a long time. - Follow the steps in the section headed "Preparing the appliance for use" see DFU (Direction For Use manual). - In stead of only water use a mix of water and Lemon sour. - For the best result leave the mix of water and Lemon sour for about 30 minutes in the appliance, before you start with flushing the appliance. - To get the best results repeat above mentioned step once or twice.