Philips 107s2-p21~p23 free download

File name 107s2-p21~p23.pdf

Electrical Adjustments 107S2 CM23 GSIII 21 9 Go to cover page 0. General 3.Monitor the following auxiliary voltages. When carry-out the electrical settings in many cases a video signal SOURCE ACROSS 7114 Pin and GRN +5 V +/- 0.25 VDC must be applied to the monitor. A computer with : SOURCE ACROSS C2155 -6.1 V +/- 0.3 VDC. SOURCE ACROSS C2141 +8.0 V +/- 0.4 VDC. - ATI GPT-1600 (4822 397 10065), Mach 64 (up to 107kHz) SOURCE ACROSS C2153 +13.1V +/- 1.0 VDC. SOURCE ACROSS C2154 - 13.1V +/- 1.0 VDC. are used as the video signal source. The signal patterns are selected SOURCE ACROSS C2151 +83.0V +/- 1.0 VDC. from the "service test software" package, see user guide 4822 727 SOURCE ACROSS C2609 - 170 V +/- 15.0 VDC. 21046 (GPT-1600). SOURCE ACROSS C2152(+ to Gnd) +180.0V +/-2.0 VDC. 4. General conditions for alignment 0.1 This monitor has 8 factory-preset modes as below. 720 x 400 31.5 kHz/70 Hz 1024 x 768 68.7 kHz/85 Hz 4.1 During all alignments, supply a distortion free AC mains voltage 640 x 480 31.5 kHz/60 Hz to set via an isolating transformer with low internal impedance. 640 x 480 43.0 kHz/85 Hz 4.2 Align in pre-warmed condition, at least 30 minutes warm-up with 800 x 600 46.9 kHz/75 Hz nominal picture brightness. 800 x 600 53.6 kHz/85 Hz 4.3 Purity, geometry and subsequent alignments should be carried 1024x768 60.0 kHz/75 Hz out in magnetic cage with correct magnetic field. 1280 x 1024 64.0kHz/60Hz 14 factory-preload modes as below Northern hemisphere : H=0, V=450 mG, Z=0 640 x 350 31.5 kHz/70 Hz 800 x 600 48.0 kHz/72 Hz Southern hemisphere : H=0, V=-500 mG, Z=0 640 x 350 37.8 kHz/85 Hz 800 x 600 64.0 kHz/100 Hz Equatorial Support : H=0, V=0 mG, Z=0 640 x 480 37.5 kHz/75 Hz 832 x 624 49.7 kHz/75 Hz 640 x 480 37.8 kHz/72 Hz 1024 x 768 48.3 kHz/60 Hz 4.4 All voltages are to be measured or applied with respect to ground. 640 x 480 50.5 kHz/100 Hz 1024 x 768 56.5 kHz/70 Hz Note: Do not use heatsink as ground. 720 x 400 38.0 kHz/