Panasonic TX-28LDM4F free download

File name PANASONIC TX-28LDM4F_TX-25LDM4F.pdf

ORDER No. SM-98020 Colour Television TX-28LDM4F TX-25LDM4F EURO4 Chassis SPECIFICATIONS (Information in brackets { } refers to model TX-25LDM4F) Power Source: 220-240V AC, 50Hz Power Consumption: Aerial Impedance: Stand-by Power Consumption: 85W 75 unbalanced, Coaxial Type AV2 OUT AV2 IN Video (21 pin) Audio (21 pin) S-Video IN (21-pin) 1V p-p 75 500mV rms 10k Y: 1V p-p 75 C:0.3V p-p 75 1,8W PAL-I, B/G, H, D/K, PAL-525/60 SECAM L/L' B/G, D/K M.NTSC NTSC (AV only) AV3 IN Receiving System: Video (21 pin) 1Vp-p 75 Audio (21 pin) 500mV rms 1k Selectable output (21 pin) Audio (RCAx2) 500mV rms 10k Video (RCAx1) 1V p-p 75 28,5kV ±1kV {28,2kV ±1kV} A66ECF50X41 66cm {A59ECF50X41 59cm} 2 x 15W (Music Power) 8 Impedance 8 Impedance High Voltage: Picture Tube: Audio Output: Headphones: Accessories supplied : Receiving Channels: VHF E2-E12 VHF H1-H2 (ITALY) VHF A-H (ITALY) VHF R1-R2 VHF R3-R5 VHF R6-R12 UHF E21-E69 CATV (S01-S05) CATV S1-S10 (M1-M10) CATV S11-S20 (U1-U10) CATV S21-S41 (HYPERBAND) Intermediate Frequency: Video Audio Remote Control 2 x R6 (UM3) Batteries Colour Video/Audio Terminals: AUDIO MONITOR OUT AV1 IN 38,9MHz, 34MHz 32,9MHz, 33,4MHz, 33,16MHz 32,4MHz, 40,4MHz, 33,05MHz 32,66MHz 34,47MHz (PAL) 34,5MHz, 34,65MHz (SECAM) Dimensions: Height: Width: Depth: Net weight: 596,5 mm 778 mm 481 mm 32kg {550,5 mm} {730 mm} {478,5 mm} {27kg} Specifications are subject to change without notice. Weights and dimensions shown are approximate. NOTE: This Service Manual should be used in conjunction with the EURO4 technical guide. Audio (RCAx2) 500mV rms 1k Video (21 pin) 1V p-p 75 Audio (21 pin) 500mV rms 10k RGB (21 pin) Video (21 pin) Audio (21 pin) 1V p-p 75 500mV rms 1k AV1 OUT 3DQDVRQLF SCHEMATIC DIAGRAMS FOR MODELS TX-28LDM4F / TX-25LDM4F (EURO-4 CHASSIS) IMPORTANT SAFETY NOTICE Components identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturer's specified parts. NOTE 1. RESISTOR All resistors are carbon јW resistor, unless marked otherwise. Unit of resistance is OHM () (k=1,000, M=1,000,000) CAPACITORS All capacitors are ceramic 50V unless marked otherwise. Unit of capacitance is µF unless otherwise stated. COIL Unit of inductance is µH, unless otherwise stated. TEST POINT Test Point Position 2. 3. 4. 5. EARTH SYMBOL Chassis Earth (Cold) Line Earth (Hot) 6. VOLTAGE MEASUREMENT Voltage is measured by a DC voltmeter. Measurement conditions are as follows: Power source AC 220V-240V, 50Hz Receiving Signal Colour Bar signal (RF) All customer controls Maximum position 7. Indicates the Video signal path Indicates the Audio signal path These schematic diagrams are the latest at time of printing and are subject to change without notice. REMARKS a. b. c. d. Do not touch the hot part, or the hot and cold parts at the same time, as you are liable to a shock hazard. Do not short circuit the hot and cold circuits as electrical components may be damaged. Do n