. Various 24xxx usb manual free download

File name 24xxx_usb_manual.pdf

USB 24xxx I2C E-Eprom programmer Fully assembled and tested Description : It is an unpretentious USB programmer for the memories of the 24xxx se- ries. The programmer is electrically supplied from the USB port. Dimensions: 6 cm x 3.5 cm Supply : The programmer uses supply from the serial port and does not need exter- nal. Tested with memories producent : Microchip, ATMEL, ST. Read-Write time : 24xx32 - approximate 15 sec. 24xx512 - approximate 240 sec. (4 min.) Software : Free, included in complete. Works under Windows 98, 2000, XP, Vista. (c) Sigma-Shop.com All rights reserved. Complete includes : - USB programmer - Software - USB cable (c) Sigma-Shop.com All rights reserved. SMD mounted EEPROM's : This programmer can be easily adapted to work with SMD mounted EEPROM using one 8 PIN socket and several finely wires. Disclaimer : In no event the author will be liable to you for damages, including any gen- eral, special, incidental or consequential damages arising out of the use or inability to use the program (including but not limited to loss of data or data being rendered inaccurate or losses sustained by you or third parties or a failure of the program to operate with any other programs), even if such holder or other party has been advised of the possibility of such damages. (c) Sigma-Shop.com All rights reserved. List of devices which programmer supports : 24C00 24C32 24AA00 24LC32A 24LC00 24AA32A 24C01 24C01C 24AA52 24AA01 24LCS52 24LC01B 24C64 24AA014 24LC64 24LC014 24AA64 24FC64 24C02 24C02C 24C65 24AA02 24LC65 24LC02B 24AA65 24AA024 24C128 24LC024 24AA128 24LC128 24AA025 24FC128 24LC025 24C256 24C04 24LC256 24AA04 24AA256 24LC04B 24FC256 24C08 24C512 24AA08 24AA512 24LC08B 24LC512 24FC512 24C16 24AA16 24AA515 24LC16B 24LC515 24FC515 24LC21 24LC21A 24C1024 24LCS21A 24LC1024 24LC22A 24AA1025 24LCS22A 24FC1025 24LC1025 (c) Sigma-Shop.com All rights reserved. Drivers and software instalation : First you have to download the drivers from here: http://www.ftdichip.com/Drivers/VCP.htm Unzip it to your own folder ... When you connect the programmer, the following message appears: FOUND NEW HARDWARE and drives need to be installed. When you connect the programmer to the PC the red and green LED flashes 2,3 times and turn off. When the red LED and the green LED flashes means that there is a communication between the programmer and PC. 1. Drivers' installation: (c) Sigma-Shop.com All rights reserved. (c)