easy_3_remote_control free download

File name easy_3_remote_control.pdf

Quick Programming Guide 1. Put the VCR/CABLE/TV switch in the desired position. 2. Simultaneously hold down the "ENTER' and "0" buttons until indicator lights. (about 5 seconds). 3. Enter the proper code number. 4. Press "ENTER'. The indicator light should turn off at once. 5. It light tails to turn off. wait until it goes out by itself, then repeat steps 1-4. Programming the Easy 3 to operate Your VCR, Cable TV Decoder and To use your new EASY 3 Remote Control it must be programmed to recognize the brands of the VCR, Cable TV descrambler and TV it will be used to operate. 1. Select the proper device mode with the VCR/CABLE/TV switch. If you wish to program a second TV or VCR use the CABLE /(`AUX.) mode. 2. Look up the code that corresponds to your brand In this Operating Guide. 3. Simultaneously hold down the ENTER and 0 buttons until the indicator lights (about 4 seconds). If ENTER is pressed immediately upon entering programming mode (before any digit key press) the EASY 3 will exit programming mode. 4. Enter the 3-digit device code. Press ENTER to enter code. If a valid device code is entered, the indicator light goes out. If an invalid code was entered the invalid code is cleared from memory and the indicator light remains lit. NOTE: If the light fails to go out as soon as the ENTER has been pressed an error has been made. 5. Test operation by using your EASY 3 to turn your component on and off. NOTE: Some manufacturers use several different types of remote control. If your brand has several numbers listed try each one until you find the one that works. 6. For future reference. write the code that was used successfully. 7. To program the EASY 3 to recognize your Cable TV Decoder, put the VCR/CABLE/TV switch In the CABLE position and repeat steps 2-5 using the code Shown in the CABLE TV DECODER CODE TABLE for your brand of decoder. NOTE: The CABLE/AUX.) position may be Used to program an additional TV or VCR instead of a Cable box 8. To program the EASY 3 for your VCR, put the VCR/CABLE/TV switch in the VCR position and repeat steps 2-5, using the appropriate code from the VCR CODE TABLE.