TOSHIBA 29AX9UM free download

File name TOSHIBA 29AX9UM .pdf

BEP 29AX9UM SUB POWER 29AX9UM SRS-WOW 29AX9UM SCHEMATIC DIAGRAM MODEL : 29AX9UM WARNING: BEFORE SERVICING THIS CHASSIS, READ THE "X-RAY RADIATION PRECAUTION", "SAFETY NOTE: PRECAUTION" AND "PRODUCT SAFETY NOTICE" ON THE MANUAL FOR THIS MODEL. 1. RESISTOR Resistance is shown in ohm [K = 1.000, M = 1.000.000]. All resistors are 1/6W and 5% 4. Voltages read with DIGITAL MULTI-METER from point indicated to chassing ground, using a color bar signal with all tolerance carbon resistor, unless otherwise noted as the following marks. controls at normal, line voltage 220 volts. CAUTION: The international hazard symbols "*" in the schematic diagram and the parts list designate components 1/2R = Metal or Metal oxide of 1/2 watt 1/2S = Carbon compsistion of 1/2 watt 5. Waveforms are taken receiving color bar signal with enough sensitivity. which have special characteristics important for safety and should be replaced only with types identical to those in the 1RF = Fuse resistor of 1 watt 10W = Cement of 10 watt 6. Voltage reading shown are nominal values and may vary ±20% except H.V. original circuit or specified in the parts list. The mounting position of replacements is to be identical with originals. K = ±10% G = ±2% F = ±1% Before replacing any of these components, read carefully the PRODUCT SAFETY NOTICE on the MANUAL for this 2. CAPACITOR Unless otherwise noted in schematic, all capacitor values less than 1 are expressed in model. Do not degrade the safety of the receiver through improper servicing. ?F, and the values more than 1 in pF. All capacitors are ceramic 50V, unless otherwise noted as the following marks. Electolytic capacitor Mylar capacitor 3. The parts indicated with " * " have special characteristics, and should be replaced with identical parts only.