Sony TVP0244 free download

File name TVP0244.pdf

TV Products CSV-1 Service Bulletin Sony Service Company - Technical Services A Division of Sony Electronics Inc. Sony Drive, Park Ridge, New Jersey 07656 Model: KV-27S10/27S15 No. 244R1 KV-27TS29/27TS32/27TS36 KV-32S10/32S15/32TS36/32TS46 Subject: Rattling Noise Countermeasure Date: May 30, 1995 Symptom: (53) Rattling noise coming from the TV. Solution: Please perform the following countermeasures Using an audio generator set to frequency range of 120~130Hz. Adjust the frequency and check if rattle occurs. If rattle occurs please perform one, or all, of the following if necessary. 1. Check if the Sony Emblems is loose. If so please perform the following: a. Carefully remove the Sony Emblem b. Apply glue (Sony Bond 7-432-912-52) to the Emblem and re attach to the Bezel. 2. Check to see if the grommet attached to the speakers is loose around the speaker mounting post. If so please perform the following: a. Apply a small amount of RTV Glue (7-322-065-19) between the rubber grommet s and speaker mounting post as illustrated below: Reference: T. Tomura PRINTED IN USA Autoflagged - NO PRINTED ON RECYCLED PAPER TV Products Service Bulletin No. 244R1 b. Allow for 12 hours of drying. c. If this fails to resolve the speaker rattle then replace the speakers as follows: Part Number of Speaker: KV-27TS xx or 32TS xx: 1-544-549-11, KV-27S xx or 32S xx: 1-504-531-11 3. Check the cabinet for vibration at the junction of the Bezel and Rear Cabinet. If this should occur please perform the following: a. Apply tape, 7-632-661-51, around the Rear cabinet making sure it will not show when the cabinets are re attached. b. Apply tape to the inside of the Bezel where the CRT touches the Bezel if rattling should occur. c. On the 32 inch Bezel, it is possible to insert double sided tape from the front of the unit by placing a finger above the Sony emblem between the Bezel and CRT. With the other hand insert the double sided tape, P/N 7-632-453-52, b