Philips p18 p20 free download

File name p18_p20.pdf

18 107P CM25 GSIII DDC Instructions 9 Go to cover page This [DDC Module (DDC cable)= 4822 320 12004(=4822 724 27550)] Connection and [DDC V2(DDCV2U.EXE) software(3.5" disk)=4822 711 00024(= 4822 724 27560)] (Rear of the monitor) are used for "BU Monitor - Chungli product range" which incorporates a DDC1/DDC2B function that allows bi-directional communication between the monitor and PC system for optimal video configuration. [July 01 1997, Revision 2.0] ,which upgrades the software and service information(4822 727 21027 & 4822 727 21038) , is fully compatible with previous one. Additional information : To video card Additional information about DDC (Display Data Channel) may be obtained from Video Electronics Standards Association (VESA). To printer port (LTP1) Extended Display Identification (EDID) information may be also be obtained from VESA. Pin assignment The 15-pin D-sub connector (male) of the signal cable (3 rows) for DDC feature : Video cable DDC data re-programming 1 5 6 10 11 15 1. General In case the DDC data memory IC, replaced due to a defect the data contents of this IC have to be re- programmed via a PC. In case of replacement of the video (or deflection) board it is advised to re-soldered DDC IC from the old board onto the new board, in this case the IC dose not need to be re-programmed. Pin No. Assignment Pin No. Assignment 1 Red video input 9 No pin 2. DDCV2N.EXE can be used for : 2 Green video input 10 Logic ground EDID Structure Version/Revision 3 Blue video input 11 Identical output