MB s es1065 free download

File name s_es1065.rar

Service manual MB Es1065 2002 . Maintenance checks To keep the performance of the copier/printer on a high level the following maintenance checks must be carried out every visit. solve the cause of the problem as described in [ Diagnostics ] replace the consumable which has reached the end of life such as. - clean brush - pin array -spiral cleaner Note: Replace the belts in the TTF unit (the TTF/ conveyer/ pre-heat) not preventive but only if they cause copy/print quality problems. The OPC can be polluted via the separation wheels. Toner and/or glue and/or rubber particles frrom the separation wheel can be transferred to the OPC. In this case try to clean the OPC . Use xxxxx . Fused toner on the OPC 1. General: Fused toner on the OPC is very difficult to remove. If a new OPC has to be installed pay attention to the items as listed below in order to prevent/reduce toner fusing. clean the glue cleaner when replacing the OPC always execute the anti-stick procedure. A new OPC may only run against a TTF belt which has made at least 20.000 copies/prints. A new OPC may NEVER come in contact with a new TTF-belt. after the anti-stick procedure print select test 46 and make at least 100 prints to decrease the stickiness of the surface of the OPC carry out test 04 7 01 to adjust the DC of the LPH . Take the first print which is background free + 6 prints extra every time the technicain replaces a new TTF belt, check the position of the NTC; see The TTF-NTC 06R2 2. The preventive maintenance 31x5 To decrease the service calls and service costs it is important to check every visit: Developing unit: Clean the edges of the magnetic roller from toner with the vacuum cleaner Clean the strip of the developing unit above the magnet roller Clean the white melinex strip in the engine OPC: When replacing the OPC always execute the anti-stick procedure. A new OPC may only run against a TTF belt which has made at least 20.000 copies/prints. A new OPC may NEVER come in contact with a new TTF-belt. carry out test 04 7 01 to adjust the DC of the LPH . Take the first print which is background free + 6 prints extra. Very high volume customers (more than 200.000 copies/ month), start after the anti- stickprocedure with the value copies with master = 40.000, SDS-test 01801. Check every visit the OPC and look if no toner is fused on the OPC, if toner is fused try to clean. If toner is fused at the edges of the OPC at about 60-70 cm after the joint, replace the spiral cleaner TTF: After replacing a new spiral cleaner, configure the value blacks with TTF belt cleaner, SDS test 06802, on 4 (so not on 0) Check the ttf-belt on damage, which comes from the edges of the paper, to much damage of the TTF-belt: replace Check the sheet of the sheetcleaners. T