LG CS580 4 free download

File name CS580_4.PDF

ADJUSTMENT GENERAL INFORMATION All adjustment are thoroughly checked and corrected Adjust H-position as center of the screen. when the monitor leaves the factory, but sometimes Adjust V-size as 190 1mm. several minor adjustment may be required. Adjust V-position as center of the screen. Adjustment should be following procedure and after Adjust side-pincushion (east-west), trapezoid distortion, warming up for a minimum of 30 minutes. and tilt should be the best condition. 3. Adjustment for the White Balance and Luminance as Alignment appliances and tools follows: - IBM compatible PC & Monitor. Set the White Balance Meter. - Programmable Signal Generator (eg. VG-819 made Press the button for demagnetized CRT of the by Astrodesign Co.) monitor. - E(E)PROM with saved each mode data. Display color 0,0 pattern at Mode 6. - Oscilloscope with probe Set Brightness and VR802 (Sub-Bright) volume to - Alignment cable with adaptor Max position. - Digital Voltmeter Set Contrast to Max and Sub-Contrast to center - Software (Alignment program for this monitor) position. - White Balance Meter Set VR301 (R-Bias) and VR302 (G-Bias) to Min - Luminance Meter position. Adjust Screen control of the FBT to 0.1FL of the raster AUTOMATIC AND M ANUAL DEGAUSSING luminance. The degaussing coil is mounted around the CRT so that external degaussing is normally unnecessary after turn Adjust VR301 (R-Bias) and VR302 (G-Bias) to on the monitor. But the monitor is moved or faced in a x=0.281 0.015 and y=0.311 0.015. different direction, become poor color purity cause of CRT Adjust VR802 (Sub-Bright) to 0.3 0.1FL of the magnetized, then press (DEGAUSSING) button to raster luminance. remove color purity problem. Display color 15,0 box pattern (70x70mm) at Mode 6. Adjust R-DRIVE 1, G-DRIVE 1, and B-DRIVE 1 to B+ ADJUSTMENT x=0.281 0.003 and y=0.311 0.003 with arrow keys. 1. Display cross hatch pattern at Mode 2.