Kyocera SB-2K3-0014-B185 free download

File name SB-2K3-0014-B185.pdf

(Page.1/2) Service Bulletin Ref. No. 2K3-0014 (B185) June 30, 2011 Improvement of the Paper Stacking Ability When Ejecting to Subject the Upper Tray Model FS-6030MFP, FS-6025MFP, FS-6025MFP/B Topic Depending on the condition of the paper printed in duplex, curled paper might push the sheet ejected before, and the page order might not be correct in case that a large volume of paper was ejected with the bridge unit attached. Therefore, the following change was made. *The phenomenon described above does not occur in case of simplex printing. Content of Changes 1) A stopper (No.1) was attached to the upper part of the inner tray in order to prevent the paper from being pushed out. This stopper was registered as a service part. (X: Stopper pulled down) (Y: Stopper pulled up) Insert the rib at the stopper part into this hole so that it will be fixed Stopper as shown on left. (Shaded area: Double-sided tape) Fig.1 (Alignment) Metal plate A No.1 Metal plate Cover B Cover No.1 1) Take the bridge unit out. 2) Attach the stopper (No.1) aligning to A and B above. 3) Pull up the stopper (No.1) and attach the bridge unit. - Pull down the stopper (No.1) when using the bridge unit. - Pull up the stopper (No.1) when using the job separator. KYOCERA MITA Europe B.V. European Service & Development Center (ESDC) (Page.2/2) Service Bulletin Ref. No. 2K3-0014 (B185)