Kyocera SB-2K3-0037-C234 free download

File name SB-2K3-0037-C234.pdf

(Page.1/6) Service Bulletin Ref. No. 2K3-0037 (C234) September 7, 2012 Measure against the Developer Unit Detection Failure (Measure against the Erroneous Display of "The developing Subject unit is not installed" or the Deformed Connector Terminal at the Developer Unit) FS-6025MFP, FS-6025MFP/B, FS-6030MFP, FS-6525MFP, Model l: FS-6530MFP Topic The detection PWB for the developer unit may be slightly slanted in counterclockwise direction depending on structural variation since there is backlash between the detection PWB and its holder in the main unit. If trying to install the developer unit to the main unit under this condition, the message "The developing unit is not installed" may not disappear, or the connector terminal on the developer unit's rear side may be deformed due to the contact with the connector holder on the detection PWB. Field Measures Please correct the angle of the detection PWB in the main unit and the deformed connector terminal on the developing unit side by following the procedures described on the next pages. Content of Changes (For more details, please refer to the page 3.) (Temporary measures) - The detection PWB in the holder is attached while aligning it rightwards. - It is checked at factory if the main unit can detect the detection PWB for the developer unit. (Permanent measure) - The rib was added to the holder to attach the detection PWB in order to prevent the detection PWB from slanting counterclockwise. (Machine inner side) NG condition OK condition (View from the main unit inner side) The connector terminal at the developing unit may be deformed by contact with the connector on the detection PWB attached while being Detection PWB slants Detection PWB slanted when installing the counterclockwise. Holder developer unit. (Not individually supplied to the field) KYOCERA Document Solutions Europe Technical Customer Service Division (TCSD) (Page.2/6) Service Bulletin