ALCATEL 511 free download

File name Techbe1-be3l04.pdf

Edition 01 02 03 04 Modification Documentation creation by association of the BE1 and BE3 technical documentation in one documentation Audio modification on BE3 Documentation correction on page 19 Flow chart and visual inspection modification ;Battery test ; new fault codes and a mandatory equipment list; Audio modification for BE1 and BE3 Date 09/03/2000 06/06/2000 13/06/2000 05/10/2000 Explanation of the modifications since the last edition Improvement Audio improvements on BE1 and BE3 products Correction Replace the audio amplifier by an Analog Device amplifier if the solder modification does not solve the problem Comments Battery test FUNCTION: Author Pilot Repair Centre Approbation 1 Pilot Repair Centre Approbation 2 Technical Assistance DATE: VISA: ED 04 09/10/00 REPAIR DOCUMENTATION BE1 and BE3 Level 2 BE 1/BE3 1/46 All rights reserved.Passing on and copying of this document, use and communication of its contents are not permitted without authorization CONTENTS 1) LEVEL 2 REPAIR PROCESS 2) TEST & VISUAL INSPECTION 3) DISASSEMBLY OF THE PRODUCT 4) HARDWARE UPGRADING 5) REPAIR 6) ASSEMBLY OF THE PRODUCT 7) STICKERS 8) CUSTOMIZATION SOFTWARE DOWNLOADING 9) FINAL TEST 9.1 Functionnal test 9.2 Measurements APPENDIX 1 FAULT CODES APPENDIX 2 EQUIPMENT FOR LEVEL 2 REPAIR CENTRE 3 4 8 20 24 27 39 41 42 42 42 43 45 ED 04 11/10/00 REPAIR DOCUMENTATION BE1 and BE3 Level 2 BE 1/BE3 2/46 All rights reserved.Passing on and copying of this document, use and communication of its contents are not permitted without authorization 1) LEVEL 2 REPAIR PROCESS start Test + visual inspection See § 2 Disassembly See § 3 Hardware upgrading See § 4 Level 2 repair See § 5 Final assembly See § 6 Rear casing is changed ? N0 YES Complete sticker printing See § 7 Customization software downloading OK See § 8 NOK To a Level 3 repair centre See § 7 Software technical level sticker Final test OK See § 9 NOK end end ED 04 09/10/00 REPAIR DOCUMENTATION BE1 and BE3 Level 2 BE 1/BE3 3/46 All rights reserved.Passing on and copying of this document, use and communication of its contents are not permitted without authorization 2) TEST & VISUAL INSPECTION ALL these verifications must be done on ALL products coming back in a LEVEL 2 after sales repair centre . a) b) Check the aspect of the rear casing and the antenna Humidity sticker : a humidity sticker is present on some BE1 terminals on the shielding that can be seen on the rear casing side, without openning the handset . Check the state of the sticker as shown below : Sticker of a good terminal Sticker of a terminal dived in water This terminal is out of the warranty c) d) e) Check J904 , the charge connector (corrosion ,contacts) Check the SIM latch right functioning Insert a SIM card and check the holding of the SIM latch Plug a good battery and switch on the handset : check the charging icon animation on the display, check the holding of the product on the desk top charge