TOSHIBA MG2012 free download

File name MG2012.PDF

SERVICE MANUAL SORTER MG-2012 Click the Page Only button to close the overview area of the window. Click the Bookmarks and Page button to open the Contents and display bookmarks created for the document. Click a bookmark's name to go to the Page marked by that bookmark. Click the Thumbnails and Page button to open the overview area and display thumbnail images of each document page. Click a thumbnail to go to the page marked by that thumbnail. Copyright TOSHIBA CORPORATION 1995 ALL RIGHTS RESERVED General Precautions for Installation/Servicing/Maintenance The installation and service should be done by a qualified service technician. 1. When installing the Stapler Sorter MG-2012 to the Plain Paper Copier, be sure to follow the instructions described in the "Unpacking/Set-Up Procedure for the MG-2012" booklet which comes with each unit of the MG-2012. 2. The MG-2012 should be installed by an authorized/qualified person. 3. Before starting installation, servicing or maintenance work, be sure to unplug the copier first. 4. When servicing or maintaining the MG-2012, be careful about the rotating or operating sections such as gears, pulleys, sprockets, cams, belts, etc. 5. When parts are disassembled, reassembly is basically the reverse of disassembly unless otherwise noted in this manual or other related materials. Be careful not to assemble small parts such as screws, washers, pins, E-rings, toothed washers to the wrong places. 6. Basically, the machine should not be operated with any parts removed or disassembled. 7. Delicate parts for preventing safety hazard problems (such as breakers, thermofuses, fuses, door switches, sensors, etc. if any) should be handled/installed/adjusted correctly. 8. Use suitable measuring instruments and tools. 9. During servicing or maintenance work, be sure to check the serial No. plate and other cautionary labels (if any) to see if they are clean and firmly fixed. If not, take appropriate actions. 10. The PC board must be stored in an anti-electrostatic bag and handled carefully using a wristband, because the ICs on it may be damaged due to static electricity. Before using the wrist band, pull out the power cord plug of the copier and make sure that there is no uninsulated charged objects in the vicinity. 11. For the recovery and disposal of used MG-2012s, consumable parts and packing materials, it is recom- mended that the relevant local regulations/rules should be followed. 12. When the sorter is to be carried, be sure to have two persons do this, holding the locations shown in the figures. 13. Install the sorter as shown in the figure below making sure that the cord is not nipped. Copyright 1997 Toshiba Corporation CHAPTER 1 GENERAL DESCRIPTIO