FUJITSU-SIEMENS V2030 Maintainance and Disassembly free download

File name V2030_Maintainance_and_Disassembly.pdf

Chapter Maintenance & Disassembly 5.1 Parts Removal and Replacement Procedures This section contains the field service-level removal/ replacement procedures for the notebook of FSC V2030 model. The notebook is designed for optimum modularity in order to make field replacement and maintenance easy and efficient. 5.1.1 Removing the Battery Pack The procedure for removing and replacing the battery pack is as follows: To remove the battery pack, first slide the left latch to left; slide the right latch to right side and hold it, then take out the battery pack with your finger. Figure 5-1 Remove the battery pack 5.1.2 Removing the Internal Hard Disk Drive The notebook provides a built-in hard disk for the primary IDE controller. The HDD is an industry standard 2.5" IDE disk drive with a maximum height of 9.5mm. 1. Find out the built-in hard disk secured with one screw at the upper of the bottom case. Remove this screw and take out the hard disk door. FSC V2030 Service Manual 5-1 PDF created with FinePrint pdfFactory trial version http://www.fineprint.com Maintenance & Disassembly One Screw Figure 5-2 Remove one screw 2. Remove two screws as picture Two Screw Figure 5-3 Remove two screws 3. Pull the hard disk module from the connector as below picture shown. 5-2 FSC V2030 Service Manual PDF created with FinePrint pdfFactory trial version http://www.fineprint.com Maintenance & Disassembly Figure 5-4 Remove HDD 4. Remove four screws of frame HDD bracket plate. Four Screws Figure 5-5 Screws Locations of the frame HDD bracket plate 5.1.3 Removing the heat sink plate The procedure for removing the heat sink plate is as follows: 1. Removing the plate, there are seven screws as the picture shown. FSC V2030 Service Manual 5-3 PDF created with FinePrint pdfFactory trial version http://www.