ricoh service.man free download

File name service.man.rar

IMPORTANT SAFETY NOTICES PREVENTION OF PHYSICAL INJURY 1. Before disassembling or assembling parts of the copier and peripherals, make sure that the copier power cord is unplugged. 2. The wall outlet should be near the copier and easily accessible. 3. Note that some components of the copier and the peripherals are supplied with electrical voltage even if the main switch is turned off. 4. If any adjustment or operation check has to be made with exterior covers off or open while the main switch is turned on, keep hands away from electrified or mechanically driven components. 5. The inside and the metal parts of the fusing unit become extremely hot while the copier is operating. Be careful to avoid touching those components with your bare hands. 6. The copier is not attached to the table. Pushing the copier too hard may cause it to drop onto the floor. While moving the copier, push the table. 7. When the main switch is turned on, the machine will suddenly start turnig to perform the developer initialization. Keep hands away from any mechanical and electrical components during this period. HEALTH SAFETY CONDITIONS 1. Never operate the copier without the ozone filters installed. 2. Always replace the ozone filters with the specified ones at the specified intervals. 3. Toner and developer are non-toxic, but if you get either of them in your eyes by accident, it may cause temporary eye discomfort. Try to remove with eye drops or flush with water as first aid. If unsuccessful, get medical attention. OBSERVANCE OF ELECTRICAL SAFETY STANDARDS 1. The copier and its peripherals must be installed and maintained by a customer service representative who has completed the training course on those models. 2. Caution: The RAM pack on the main control board has a lithium battery which can explode if replaced incorrectly. Replace the RAM pack only with an identical one. The manufacturer recommends replacing the entire RAM pack. Do not recharge or burn this battery. Used RAM packs must be handled in accordance with local regulations. SAFETY AND ECOLOGICAL NOTES FOR DISPOSAL 1. Do not incinerate the toner cartridge or the used toner. Toner dust may ignite suddenly when exposed to open flame. 2. Dispose of used toner, developer, and organic photoconductors according to local regulations. (These are non-toxic supplies.) 3. Dispose of replaced parts in accordance with local regulations. 4. When keeping used RAM packs in order to dispose of them later, do not put more than 100 RAM packs per sealed box. Storing larger numbers or not sealing them apart may lead to chemical reactions and heat build-up. SECTION 1 OVERALL MACHINE INFORMATION 31 October 1994 SPECIFICATIONS 1. SPECIFICATIONS Configuration: Table top Copy Process: Electrostatic transfer system Original Feed: Sheet feed Original Size: