Samsung 06 Disassembly & Reassembly free download

File name 06_Disassembly & Reassembly.pdf

11 Disassembly and Reassembly 11 Disassembly and Reassembly This section of the service manual describes the disassembly and reassembly procedures for the LW15M23CP/ LW17M24CP/LW20M21CP LCD TV. WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling these components. 11-1 LW15M23CP, LW15M25CP Disassembly Cautions: 1. Disconnect the monitor from the power source before disassembly. 2. Follow these directions carefully; never use metal instruments to pry apart the cabinet. 1. Place monitor face down on cushioned table. Remove 4 screws from grip on the stand and remove stand from the LCD TV 2. Remove 2 screws from the rear cover and lift up rear cover. 11-1 11 Disassembly and Reassembly 3. Remove 11 screws from the boards and disconnect inverter cables from the boards. 4. Disconnect LVDS cable, function cable and speaker cable from the board. 5. Lift up the boards and remove 8 screws from the panel shield. 11-2 11 Disassembly and Reassembly 6. Lift up the panel shield and disconnect panel from the front. 11-2 LW17M24CP Disassembly 1. Place LCD TV face down on cushioned table. Remove 4 screws from the stand. 2. Remove 3 screws from the rear cover and lift up the rear cover. 11-3 11 Disassembly and Reassembly 3. Remove 13 screws from the boards and remove 2 hold inverter from the boards. Disconnect inverter cable, speaker cable, control cable, BRKT AC cable and LVDS cable from the boards. 4. Disconnect cables and Lift up the boards and remove 8 screws from the shield panel. 5. Lift up the panel shield and lift up the panel. 11-4 11 Disassembly and Reassembly 6. This picture shows cover front after disconnecting the panel from it. 11-3 LW20M21CP, LW20M25CP Disassembly 1. Place LCD TV face down on cushioned table. Remove 4 screws from the grip on the stand. 11-5 11 Disassembly and Reassembly 2. Remove 3 screws on stand and disconnect cover rear after inserting stand completely into stand. (Note : If stand is loosely inserted into stand, cover rear can be damaged when disconnected.) 3. Disconnect inverter holder wire from the board and carefully reomve the silicon glue on the LVDS cable with a nipper. 4. Disconnect function cable, speaker cable, inverter cable and LVDS cable from the board. 11-6 11 Disassembly and Reassembly 5. Remove 8 screws