ONKYO SL105 free download

File name SL105.pdf

SL-105 SERVICE MANUAL SUB WOOFER SYSTEM Ref. No.3709 082001 SL-105 / HTP-2 D-L5 x 5 SATELLITE SPEAKERS SL-105 POWERED SUBWOOFER Black color : MPP model Yellow color : MDT, MGT models MPP MDT MGT 230-240V AC, 50Hz 120V AC, 60Hz 220-230V AC, 50/60Hz SAFETY-RELATED COMPONENT WARNING!! COMPONENTS IDENTIFIED BY MARK ON THE SCHEMATIC DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR RISK OF FIRE AND ELECTRIC SHOCK. REPLACE THESE COMPONENTS WITH ONKYO PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL. MAKE LEAKAGE-CURRENT OR RESISTANCE MEASUREMENTS TO DETERMINE THAT EXPOSED PARTS ARE ACCEPTABLY INSULATED FROM THE SUPPLY CIRCUIT BEFORE RETURNING THE APPLIANCE TO THE CUSTOMER. SL-105 SERVICE NOTE 1. Replacing the fuses This symbol located near the fuses indicates that the fuse used is fast operating type. For continued protection against fire hazard, replace with same type fuse. For fuse rating refer to the marking adjacent to the symbol. Ce symbole indique que le fusible utlise est a rapide. Pour une protection permanente, n'untiliser que fusibles de meme type. Ce darnier est la qu le present symbol est appse. CIRCUIT NO. PART NO. DESCRIPTION CIRCUIT NO. PART NO. DESCRIPTION F901,F903 F902 252069 or 252236 252159 or 252253 0.8A-SE-EAK or 800MA-SE-TL250V 2A-UL/T-237 or 2A-T/UL-ST2 2. Safety-check out After correcting the original service problem, perform the following safety check before releasing the set to the customer. Connect the insulating-resistance tester between the plug of power supply cord and screw on the back panel. Specifications: 3.3Mohm SL-105 PANEL VIEW Subwoofer SL-105 Front panel 2 POWERED SUBWOOFER FREQUENCY OUTPUT LEVEL 3 Rear panel SL-105 SL-105 INPUT FROM AMP/RECEIVER C SPEAKER LEVEL + R _ _ L + LINE INPUT AUTO STANDBY L (MONO) OFF ON OUTPUT TO SPEAKERS R + R _ _ L + 50 Hz 200 Hz MIN MAX D A B POWER 1 To AC outlet A Low-level input jacks (LINE INPUT) Connect these jacks to the LINE OUT jacks of the amplifier etc. B Auto standby switch (AUTO STANDBY) This switch is used to turn on and off the auto standby function. ON: This activates the auto standby function. If a constant level signal is not received from the amplifier (or receiver) over a period of a few minutes, the SL-105 automatically enters the standby state. If a constant level signal is later received from the amplifier (or receiver), the power is automatically turned back on. OFF: Deactivates the auto standby function. Notes: * The auto standby function operates on the existence or absence of a constant level input signal. If the auto standby function does not operate properly, try slightly increasing (or decreasing) the output level of the amplifier or receiver. (Note that output levels of some amplifiers and receivers cannot be adjusted. For more details regarding your components, refer to the instruction manual supplied with them.) * If noise from peripheral components causes the or if incorrect operation