Philips FC9023 free download

File name _vacuum_cleaner_®_.pdf

Universe Vacuum cleaner FC9023 Philips Domestic Appliances and Personal Care Service Manual PRODUCT INFORMATION - This product meets the requirements regarding interference suppression on radio and TV. - After the product has been repaired, it should function properly and has to meet the safety requirements as officially laid down at this moment. TECHNICAL INFORMATION - Colour : - Maximum air displacement : - Maximum vacuum water column : - Power consumption (IEC) 230 V : - Duststorage capacity : - Type number dustbag : - Cord length (depends on version) : - Filter system : : : - Dimensions of cleaner : - Dimensions of packaging : - Net weight : - Gross weight : OPTIONAL (accessories) FC8021 FC8030 FC8031 FC8034 FC8042 FC8043 S-bags AFS-filter HEPA Air Filter Upgrate kit Active Carbon Filter Polishing nozzle Turbo brush nozzle DISASSEMBLY- AND RE-ASSEMBLY ADVISE - Open the appliance, first remove the exhaust filter grille (item 20), and then remove the 2 screws - C of the switch control panel (item 15). C 2x C 9x 14a + b Crystal white 37 l/sec. 310 cm 1500 W 3L FC8021 7 metres Paper dustbag Exhaust HEPA air filter Motor inlet filter 460 x 315 x 270 mm 595 x 395 x 295 mm 5.88 kg 9.135 kg - To remove the the panel, pos 14a + b must be removed by using a screwdriver to separate the two covers from the panel as shown in the picture. - Undo and remove the 9 screws (T15) - C in the upper housing (item 8). You will require a screwdriver with a 14.5 cm-long shank for this. Srewdriver 4322 009 08490 can be used. - Item 8 Spare part is standard supplied without a hole, you must drill a hole 2mm dia, so the air can reach the sensor on the PCB via the pressure tube. Ш 2mm - Item 22 Replace the HEPA filter as soon as the pilot light of the filterfull indicator goes on. - The component configuration shown in the exploded view may differ in case of specific versions. The components are distinguished by means of code numbers. - When the repair is finished, check whether all functions of the appliance work properly. - To disassemble the cord winder, use TORX screwdriver no. T10, which is one of a set consisting of T20; T15; T10; T9; T8; T7 and T6 (code number 4822 395 50145). © Copyright reserved Subject to modification Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands 03/03 FC9023 REPAIR INSTRUCTION - Item 4, cotton dustbag, is used in countries in which paper dustbags are not available. - If the reel half spring unit is replaced, shaft A must be lubricated with silicone grease. Do not apply any silicone grease to or spill any grease on terminals (43) or conductors (42). - Item 40 is provided with a long cord-winder spring, but both long and short cords can be used in combination with this spring. (L = 9.3 m) - Depending on the original cord, the spare cord must be shortened to the length of the original cord. - The cord winder spring must be tensioned to the maximum level and then be rewound approx. 1.5 turn - Item 1