Philips FC6841/A FC6842/A free download

File name vacuum_cleaner_®_.pdf

Vacuum Cleaner FC 6841/A ! Service Information Philips Domestic Appliances and Personal Care Service Manual PRODUCT INFORMATION Type no. name Versions Voltage Power Air displacement Vacuum (water col.) Noise level Capacity : : : : HR 68xx Triathlon (dry, wet and shampoo) FC 6841 = red 230 V a.c. 50 Hz; 240 V a.c. 50 Hz 1300 W (IEC) / 1500 W max. SERVICE INFORMATION Accessories: See drawing for replacing of the shampoo pressure hose, for example the pistol handgrip. Motor unit: The type no. plate is placed on the outside of the lower housing (38). To open the motor unit, remove the inlay by pressing the inlay on the cord winder push-button and remove 2 screws (E). (The inlay is mounted on the cover by means of a snap construction). Use a long Philips screwdriver 9965 000 08332 to remove the 6 screws (F) of the lower housing / top housing. (Holes in lower housing are 13 cm deep). For safety reasons, make sure that the cap clamps do not come above the panel surface (31) after replacing of the switch (30). If the lower housing (38) must be separated from the top housing (15) always replace waterproofing foam (22). Press hard on the housing during assembly of this unit to prevent the foam from moving during assembly. : 51 l/sec. measured without accessories : 230 cm measured without accessories : 77 dB : Supply tank 3 litres (2) Recovery tank 9 litres wet (7) Recovery tank 17 litres dry (7) Dust bag (HR 6947) 10 litres dry (39) Cord length : 6.3 or 9.3 m (depends on the national version) Shampoo system : Motorised pump Air exhaust : AFS-MICRO filter FC 8032 Dimensions : 46 x 45 x 32 cm Net weight : 8.3 kg (without tools) OPTIONAL FC 8032 HR 6947 : AFS-MICRO filters 4822 015 70056. Item 20 : Athena 8836 947 01000 = 4822 015 70058 Contains: 4 Paper dust bags, 1 motor filter and 1 AFS-MICRO filter. Items 29, 24 and 20 : Cleaning liquid for carpets 4822 390 80176 : Turbo nozzle : Twist and clean nozzle This product meets the requirements regarding interference suppression on radio and TV. HR 6965 FC 8043 FC 8042 After the product has been repaired, it should function properly and has to meet the safety requirements as officially laid down at this moment. Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification 4322 277 00897 02/03 The cord winder lever (14) must be assembled through the top cover at an angle (as shown in the figure) to operate the cord winder. Depending on the national version, the cleaner has a 6.3 or 9.3 m cord. The spring unit (101) is standard provided with a 9.3 m spring. To demount the cord winder use TORX screw driver no. T15, which is one of a set consisting of T20, T15, T10, T9, T8 and T6 4822 395 50145. To check the shampoo circuit, it is neccessary to use the male plug (61) to open the valve in the female plug (32). If pos. 101 is replaced, shaft A must be lubricated with silicone grease (A). This grease may not be used on terminals (103)