Scantronic 9800 free download

File name 9800.pdf

9800 Installation and User Guide Compatible Equipment 9825 9827 9040 9056 9076-01/02 960 9066 Remote Keypad Remote Keypad Internal loudspeaker (16 Ohm). 2 max, fit at least one. Plug-on Digital Communicator Signalling Relay Interface Speech/Digital Communicator Self-Activating Bell (SAB) Module 496334 Issue 1 1 of 14 9800 Introduction The 9800 Alarm Control Panel comprises a control unit in a shielded case, and up to four separate keypads. The control unit provides: ° Connections for up to eight Closed Circuit zones. ° Connections for four outputs (external sounder, strobe, and two fully programmable outputs). ° Connections for up to four 9825 Keypads. ° Pins for fitting a plug-on communication device. Any device that complies with the Scantronic plug-on footprint can be fitted. ° Internal sounder loudspeaker output with electronically generated Chime, Alarm and Fire tones. The programming interface is arranged as a set of two-digit numbered commands. The system can provide for up to 4 separate users. User facilities include: ° Three different security levels (full set and two part sets) which can be programmed by the installer. ° User programmable Duress code. ° Keyswitch setting/unsetting. Technical Specifications General Operating temperature Humidity Dimensions Weight Standby Battery = -10 °C to + 40 °C. = Up to 80% non-condensing. = h x w x d 300 x 300 x 75 mm. = 4.85 Kg (excl battery). = 12 Volt, 6.0Ah rechargeable lead-acid, Gel Type battery. Power Supply The total current available from the control unit is as follows: System output current = 800mA (Ambient Temp. 20 °C). Control unit pcb = 60mA quiescent. = 500mA active (when driving standard external bell). Each 9825 Remote Keypad = 20mA quiescent. = 60mA active. 2 of 14 496334 Issue 1 9800 9825 Keypad Addressing Standard 9066 SAB Module Plug-on 9056 Communicator = 40mA. = 40mA. Keypad Wiring Recommended maximum distances for the remote keypads from the control unit, using standard alarm cable is 100 metres for the star configuration. Outputs OP1, OP2, Bell, Strobe = 500mA. Transistorised outputs capable of driving a relay. 9825 Keypad Addressing Before connecting the keypad(s) to the system, the engineer must set the address of each keypad. Each keypad in a system must have a different address number to ensure that the control unit can correctly identify them. To set the address: 1. Ensure the system is powered down. 2. Open the keypad and identify the four position DIP switch on the keypad pcb, see Figure 1 below. Note that each switch is numbered 1 to 4. The numbers correspond to the keypad address. Figure 1. Keypad Address Switch Select one switch and move it to the ON position (up). Make sure all the other switches are OFF (down). The keypad now has the address given by the switch that is ON. Adjusting Keypad Sounder Volume You can alter the volume of the keypad sounder by adjusting the potentiometer located next to the sounder. See Figure 1. When first installing th