Supra S21F7A free download

File name 3p51 pg 23-3506.8.21.pdf

Purity and Convergence Adjustment COLOR PURITY ADJUSTMENT (1) Before color purity adjustment,warm up the TV set over 15 minutes and fully degauss. (2) Receive pure white signal in AV status and set the TV receiver dynamic. (3) Go to factory mod MENU2. After write down the values of R-BIAS and B-BIAS, set the values of RBIAS and B-BIAS zero. (4) Loosen the clamp screw of the deflection yoke and pull the deflection yoke towards color purity Magnetic loop. (5) Adjust color purity magnetic loop to make the green area at the center of CRT screen. (6) Slowly push the deflection yoke toward the front of CRT and set it where a uniform green field is Obtained. Tighten the clamp screw of the deflection yoke. (7) Restore the values of R-BIAS,G-BIAS AND B-BIAS. CONVERGENCE ADJUSTMENT (1) Receive a dotted pattern. Set the TV receiver dynamic. (2) Loose the convergence magnet clamperrrrr and align red with blu dots at the center of the screen by rotating(R,B) static convergence magnets. (3) Align Red/Blue with green dots at the center of the screen by rotating(RB-G) static convergence magnet. (4) Remove the DY wedges and slightly tilt the deflection yoke horizontally and vertically to obtain the good Purity Magnet RB-G Magnet Clamper RB Static Magnet -23- Control Location CONTROL LOCATION 1. Remote Sensor 2. Power Indicator 3. Main Switch 4. Speakers 5. Program Down & Up Button 6. Volume Down & Up Button 7. Menu Button 8. AV/TV Button 9. Front AV In (Option) 10. AC Power Cord 11. AV Out 12. AV In1 13. YUV(Y, Cb, Cr) In 14. Antenna Input Socket (75 Ohm) 4 9 5 6 7 8 2 1 3 4 10 11 12 13 14 - 24 - Input and Output Terminals INPUT AND OUTPUT TERMINALS YCbCr IN AV OUT AV IN 1 Y S-VIDEO AUDIO AUDIO Cb VIDEO VIDEO Cr NOTE For Australia only - Install an external aerial conforming to AS 1417.1 for safety purpose. Precautions when connecting to other equipment When using external equipment with this TV set, please read the instruction manual for the external equipment. Switch off all power supplies to the equipment and TV set before connection. Always ensure that the input and output terminals are correctly connected. - 25- Operation Instructions OPERATION INSTRUCTIONS WARNING: The main power switch ( No.1 of the control location page ) is the manually operated mechanical switch . The remote control can not cut off power supply to the TV set. For safety purpose, push main switch to the OFF position and make sure the power indicator go out when not use for long time. Push the power "ON/OFF"switch to the ON position, and then power indicator will light up, the picture(or blue screen) will appear within a few seconds. MENU BUTTON 1.Press this button to select PICTUREm .u a in le y c ў Ў G A H C X N P U T S E M I PICTURE TIME SETUP TUNE EXCHANGE 2.After entering into each menu, you can select submenu which you will adjust with PROG.+/- Buttons or (GREEN) /BLUE buttons. Then you can adjust it with VOL.+/- Buttons or the +(RED) / - (YE