Nissan 90 ~93 free download

File name instrument panel analog.pdf

INSTRUMENT PANEL - ANALOG 1993 Nissan Sentra 1993 ACCESSORIES/SAFETY EQUIPMENT Nissan Instrument Panels - Analog Sentra DESCRIPTION Analog (needle-type) gauges are mounted on instrument cluster (combination meter). Oil pressure sending switch is located near oil filter. TESTING MAIN POWER SUPPLY Remove instrument cluster. Turn ignition on. Check voltage between ground and specified terminal of instrument cluster connector. See MAIN POWER SUPPLY TEST TERMINALS table. See Fig. 3 or 4. If battery voltage is not present, check for blown fuse, open fusible link, open in wiring harness, faulty ignition relay and/or faulty ignition switch. MAIN POWER SUPPLY TEST TERMINALS TABLE Application With Tachometer ... Without Tachometer ... Remove cap and brake level switch from brake fluid reservoir. Clean any foreign material from terminal connector. Using an ohmmeter, check brake level switch continuity. With brake fluid switch float raised, continuity should not exist. With brake fluid switch float lowered, continuity should exist. Remove instrument cluster, leaving connectors attached. Turn ignition on. Connect a jumper wire between ground and fuel gauge terminal on back on instrument cluster for less than 10 seconds. See Fig. 3 or 4. If fuel gauge does not move smoothly from EMPTY to FULL, replace fuel gauge. Remove sending unit from fuel tank. Measure resistance between terminals "G" (+) and "E" (-) of sending unit connector. See Fig. 1. If resistance values are not about equal to values specified in FUEL GAUGE SENDING UNIT RESISTANCE table, or if values do not change smoothly, replace fuel gauge sending unit. ЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎ ЎЎЎЎЎЎЎЎ ЎЎ ЎЎЎЎ Ў ЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎ ЎЎЎЎЎЎЎЎ ЎЎ ЎЎЎЎ Ў BRAKE FLUID LEVEL LIGHT FUEL GAUGE FUEL GAUGE SENDING UNIT Terminal No. 16 15 Fig. 1: Fuel Gauge Sending Unit Connector Terminal ID Courtesy of Nissan Motor Co., U.S.A. FUEL GAUGE SENDING UNIT RESISTANCE TABLE (OHMS) Application Sentra Remove fuel gauge sending unit. Connect 12-volt battery across terminals "E" and "S" of fuel gauge sending unit connector, with a 3.4-watt light bulb connected in series. See Fig. 2. Allow time for light bulb to come on. With sending unit float submerged in gasoline, light should not come on. Fig. 2: Testing Low Fuel Warning Light Sensor Courtesy of Nissan Motor Co., U.S.A. ЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎ Full 4-6 Half ... ... 28-34 ... Empty 73-85