Samsung 330TFT free download

File name SyncMaster_330TFT.pdf

COLOR MONITOR SyncMaster SyncMaster SyncMaster SyncMaster 330TFT 530TFT 331TFT 531TFT SERVICE COLOR MONITOR Manual CONTENTS 1. Precautions 2. Reference Information 3. Product Specifications 4. Operating Instructions 5. Disassembly & Reassembly 6. Troubleshooting 7. Exploded View & Parts List 8. Block Diagram SAMSUNG EXIT MENU - + 9. Electrical Parts List 10. PCB Diagrams 11. Wiring Diagram 12. Schematic Diagrams Samsung Electronics Co., Ltd. July 1998 Printed in Korea Code No.: BN68-60017A 1 Precautions Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as electrical shock. 1-1 Safety Precautions 1-1-1 Warnings 1. 2. 3. For continued safety, do not attempt to modify the circuit board. Disconnect the AC power and DC Power Jack before servicing. When the chassis is operating, semiconductor heatsinks are potential shock hazards. DEVICE UNDER TEST TEST ALL EXPOSED METAL SURFACES (READING SHOULD NOT BE ABOVE 0.5mA) LEAKAGE CURRENT TESTER 1-1-2 Servicing the LCD Monitor 1. When servicing the LCD Monitor, remove the static charge by connecting a 10k ohm resistor in series with an insulated wire (such as a test probe) between the chassis and the anode lead. (Disconnect the AC line cord from the AC outlet.) It is essential that service technicians have an accurate voltage meter available at all times. Check the calibration of this meter periodically. 2-WIRE CORD ALSO TEST WITH PLUG REVERSED (USING AC ADAPTER PLUG AS REQUIRED) EARTH GROUND 2. Figure 1-1. Leakage Current Test Circuit 4. With the unit completely reassembled, plug the AC line cord directly into a 120V AC outlet. With the unitХs AC switch first in the ON position and then OFF, measure the current between a known earth ground (metal water pipe, conduit, etc.) and all exposed metal parts, including: metal cabinets, screwheads and control shafts. The current measured should not exceed 0.5 milliamp. Reverse the power-plug prongs in the AC outlet and repeat the test. 1-1-3 Fire and Shock Hazard Before returning the monitor to the user, perform the following safety checks: 1. Inspect each lead dress to make certain that the leads are not pinched or that hardware is not lodged between the chassis and other metal parts in the monitor. Inspect all protective devices such as nonmetallic control knobs, insulating materials, cabinet backs, adjustment and compartment covers or shields, isolation resistor-capacitor networks, mechanical insulators, etc. Leakage Current Hot Check (Figure 1-1): WARNING: Do not use an isolation transformer during this test. Use a leakage current tester or a metering system that complies with American National Standards Institute (ANSI C101.1, Leakage Current for Appliances), and Underwriters Laboratories (UL Publication UL1410, 59.7). 2. 1-1-4 Product Safety Notices Some electrical and mechanical parts have special safety-related characteristics which are often not evident from visual inspection.