SONY HDR-HC9 free download

File name SONY HDR-HC9, HC9E SECTION 6 ADJUSTMENTS ADJ VER 1.1 2008.05 (9-852-225-52).pdf

HDR-HC9/HC9E RMT-831 Ver. 1.1 2008.05 Revision History SECTION 6 ADJUSTMENTS ADJ Link Before starting adjustments Adjusting items when replacing main parts and boards List of service tools VIDEO SECTION ADJUSTMENTS PREPARATIONS BEFORE ADJUSTMENTS SYSTEM CONTROL SYSTEM ADJUSTMENTS SERVO AND RF SYSTEM ADJUSTMENTS CAMERA SECTION ADJUSTMENTS PREPARATIONS BEFORE ADJUSTMENTS VIDEO SYSTEM ADJUSTMENTS AUDIO SYSTEM ADJUSTMENTS INITIALIZATION OF EVR DATA CAMERA SYSTEM ADJUSTMENTS ELECTRONIC VIEWFINDER SYSTEM ADJUSTMENTS LCD SYSTEM ADJUSTMENTS SERVICE MODE ADJUSTMENT REMOTE COMMANDER (RM-95) ADJUSTMENT REMOTE COMMANDER (NEW LANC JIG) DATA PROCESS MECHANISM SECTION ADJUSTMENTS HOW TO ENTER RECORD MODE WITHOUT CASSETTE HOW TO ENTER PLAYBACK MODE WITHOUT CASSETTE TAPE PATH ADJUSTMENT SERVICE MODE NTSC MODEL: HDR-HC9 PAL MODEL: HDR-HC9E HDR-HC9/HC9E_ADJ 9-852-225-51 Sony EMCS Co. 2008E0800-1 © 2008.05 Published by Kohda TEC SECTION 6 ADJUSTMENTS 1. Before starting adjustments EVR Data Re-writing Procedure When Replacing Board The data that is stored in the repair board, is not necessarily correct. Perform either procedure 1 or procedure 2 or procedure 3 when replacing board. Procedure 1 Save the EVR data of the machine in which a board is going to be replaced. Download the saved data after a board is replaced. (Machine before starting repair) PC PC (Machine after a board is replaced) Save the EVR data to a personal computer. Download the saved data to a machine. Procedure 2 Remove the EEPROM from the board of the machine that is going to be repaired. Install the removed EEPROM to the replaced board. Remove the EEPROM and install it. (Former board) (New board) Procedure 3 When the data cannot be saved due to defective EEPROM, or when the EEPROM cannot be removed or installed, save the data from the same model of the same destination, and download it. (Machine to be repaired) PC (Machine to be repaired) Download the data. Save the data. (The same model of the same destination) After the EVR data is saved and downloaded, check the respective items of the EVR data. (Refer to page 6-3 for the items to be checked) HDR-HC9/HC9E_ADJ 6-1 1-1. Adjusting items when replacing main parts and boards · Adjusting items when replacing main parts When replacing main parts, adjust the items indicated by z in the following table. Note 1: When replacing the drum assy or the mechanism deck, reset the data of page: 7, address: A8 to AB to "00". (Refer to "Record of Use check" of "6-4. SERVICE MODE") Replaced part Block replacement Mounted part replacement Initialization of EVR data Camera EVF LCD Mechanism System control Servo, RF Video Initialization of A, B, D, 1A, 1B page data Initialization of 8, 9, C, 13, 18, 1C, 1D page data Initialization of F, 63 to 6F page data Initialization of 7C, 7E, 7F page data Origin oscillation check HALL adj. HALL/MR adj. Differential gain adj. Flange back adj. F No. & ND light quality standard data input Mechanical