SONY HDR-FX1000 free download

File name SONY HDR-FX1000, FX1000E SECTION 6 ADJUSTMENTS ADJ VER 1.2 2009.03 (9-852-622-53).pdf

HDR-FX1000/FX1000E RMT-831 Ver. 1.2 2009.03 Revision History SECTION 6 ADJUSTMENTS ADJ Link Before starting adjustments Adjusting items when replacing main parts and boards List of service tools VIDEO SECTION ADJUSTMENTS PREPARATIONS BEFORE ADJUSTMENTS SYSTEM CONTROL SYSTEM ADJUSTMENTS SERVO AND RF SYSTEM ADJUSTMENTS CAMERA SECTION ADJUSTMENTS VIDEO SYSTEM ADJUSTMENTS PREPARATIONS BEFORE ADJUSTMENTS AUDIO SYSTEM ADJUSTMENTS INITIALIZATION OF EVR DATA CAMERA SYSTEM ADJUSTMENTS ELECTRONIC VIEWFINDER SYSTEM ADJUSTMENTS LCD SYSTEM ADJUSTMENTS SERVICE MODE ADJUSTMENT REMOTE COMMANDER (RM-95) ADJUSTMENT REMOTE COMMANDER (NEW LANC JIG) DATA PROCESS MECHANISM SECTION ADJUSTMENTS HOW TO ENTER RECORD MODE WITHOUT CASSETTE HOW TO ENTER PLAYBACK MODE WITHOUT CASSETTE TAPE PATH ADJUSTMENT SERVICE MODE NTSC MODEL: HDR-FX1000 PAL MODEL: HDR-FX1000E HDR-FX1000/FX1000E_ADJ 9-852-622-53 Sony EMCS Co. 2009C0800-1 © 2009.03 Published by Kohda TEC SECTION 6 ADJUSTMENTS 1. Before starting adjustments EVR Data Re-writing Procedure When Replacing Board The data that is stored in the repair board, is not necessarily correct. Perform either procedure 1 or procedure 2 or procedure 3 when replacing board. Procedure 1 Save the EVR data of the machine in which a board is going to be replaced. Download the saved data after a board is replaced. (Machine before starting repair) PC PC (Machine after a board is replaced) Save the EVR data to a personal computer. Download the saved data to a machine. Procedure 2 Remove the EEPROM from the board of the machine that is going to be repaired. Install the removed EEPROM to the replaced board. Remove the EEPROM and install it. (Former board) (New board) Procedure 3 When the data cannot be saved due to defective EEPROM, or when the EEPROM cannot be removed or installed, save the data from the same model of the same destination, and download it. (Machine to be repaired) PC (Machine to be repaired) Download the data. Save the data. (The same model of the same destination) After the EVR data is saved and downloaded, check the respective items of the EVR data. (Refer to page 6-3 for the items to be checked) HDR-FX1000/FX1000E_ADJ 6-1 Ver. 1.1 2008.11 The changed portions from Ver. 1.0 are shown in blue. 1-1. Adjusting items when replacing main parts and boards · Adjusting items when replacing main parts When replacing main parts, adjust the items indicated by z in the following table. Note 1: When replacing the drum assy or the mechanism deck, reset the data of page: 7, address: A8 to AB to "00". (Refer to "Record of Use check" of "6-4. SERVICE MODE") Note 2: If the lens is broken, it must be replace with the already adjusted lens. Replaced part Block replacement PRISM device (Inclding CM-097 and CM-104 board and CMOS imager (IC3001/IC5001)) Mounted part replacement (PITCH, YAW sensor) (Oscillator) (Camera signal processor) (Base band signal processor, etc.) (DV signal processor, etc.) (Video out AMP) (Component