Kenwood XS300 free download

File name Kenwood-XS300 cass.pdf

STEREO CASSETTE DECK X-S300 SERVICE MANUAL © 1997-6/B51- 5325-00 (K/K) 2147 Knob (K27-2211-04) Knob assy (K29-6676-04) Escutcheon (B07-2344-02) Knob assy (K29-6678-04) Panel (A60-1148-11) POWER DOLBY STEREO CASSETTE DECK X-S300 0 7 - ON ­ OFF O.T.E. CCRS REV. MODE COUNTER RESET REC LEVEL ¶ 8 1 Ў 2 3 Knob (K29-6680-02) Panel assy (A29-0869-03) Front glass (B10-2356-12) Knob (K29-6680-02) Power cord bushing (J42-0083-05) LINE REC IN L PLAY OUT SYSTEM CONTROL AC 110 120V ~ AC 220 240V ~ R Phono jack (E63-0136-05) Miniature phone jack (E11-0293-05) Slide switch (S62-0001-05) AC power cord * (E30-) * Refer to parts list on page 13. X-S300 CONTENTS / ACCESSORIES Contents CONTENTS / ACCESSORIES ...2 ADJUSTMENT ...3 PARTS DESCRIPTIONS ...4 PC BOARD ...5 SCHEMATIC DIAGRAM ...7 EXPLODED VIEW ...11 PATS LIST ...13 SPECIFICATIONS ...17 Accessories Check that the following accessories are present. Audio cord ...(2) (E30-0505-05) System control cord...(1) (E30-2816-05) * AC plug adapter ...(1) (E03-0115-05) * Use to adapt the plug on the power cord to the shape of the wall outlet (Accessory only for regions where use is necessary.) 2 X-S300 ADJUSTMENT NO. ITEM INPUT SETTING OUTPUT CASSETTE TAPE SETTING DECK SETTING ALIGNMENT POINTS ALIGN FOR FIG. Unless otherwise specified, set the respective switches as follows: TAPE : NORMAL DOLBY : OFF I Cassette mechanism unit (Adjustment of the REC / PLAY head) 0dBs = 0.775V (1) Demagnetization and cleaning -- -- Power : OFF Demagnetization, cleaning, PLAY Recording head, erase head, capstan pinch roller Demagnetize the REC / PLAY head with the head eraser. Clean the REC / PLAY head, erase head, capstan and pinch roller using a cotton swab slightly damped with alcohol. (2) Azimuth of the REC / PLAY head SCC-1727 TCC-153 MTT-114 10kHz, -10dB (B) PLAY RVS Adjust the output to maximum and adjust the azimuth adjustment screw for the Lissajours waveform pattern of the oscilloscope to become close to a FWD 45° straight ling. II PC BOARD ADJUSTMENT TCC-110 MTT-111 SCC-1727 3kHZ (1) TAPE SPEED (NORMAL) (B) PLAY VR7 Adjust the tape speed so that 3kHz is obtained at the center of the tape. III PC board adjustment. MTT-150 400Hz (1) PLAYBACK LEVEL MTT-256, SCC-1727 315Hz MTT-256U, TCC-120 315 Hz (A) Adjust the AG for the output of the DECK to become 12.5KHz ­20dBs. 400Hz/12.5kHz (AC-224) (A) Adjust the AG for the output of the DECK to become 1kHz ­20dBs. (B) PLAY VR 1 (L) VR 2 (R) Adjust the playback output to ­1dBs. Adjust the playback outp