Sony STRDE197 free download

File name Sony-STRDE197 rec.pdf

STR-DE197 SERVICE MANUAL Ver. 1.2 2006. 02 US Model Canadian Model AEP Model Photo: Black type SPECIFICATIONS AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code US only) With 8 ohm loads, both channels driven, from 20 ­ 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09 % total harmonic distortion from 250 milliwatts to rated output. Amplifier section POWER OUTPUT Models of area code US, CND Power Output at Stereo Mode (8 ohms 1 kHz, THD 0.7 %) 125 W + 125 W 1) Models of area code AEP Power Output at Stereo Mode (8 ohms 1 kHz, THD 0.7 %) 100 W + 100 W 1) 1) Measured under the following conditions: Area code Power requirements US, CND 120 V AC, 60 Hz AEP 230 V AC, 50 Hz Frequency response CD, MD/TAPE, VIDEO 1, 2 Outputs (Analog) MD/TAPE (OUT), VIDEO 1 (AUDIO OUT) Bass Boost: Tone: Voltage: 500 mV Impedance: 10 kilohms +8 dB at 70 Hz ±10 dB at 100 Hz and 10 kHz FM tuner section Tuning range Antenna Antenna terminals Intermediate frequency Sensitivity Mono: Stereo: Usable sensitivity S/N Mono: Stereo: Harmonic distortion at 1 kHz Mono: Stereo: Separation Frequency response Selectivity 87.5 ­ 108.0 MHz FM wire antenna 75 ohms, unbalanced 10.7 MHz 18.3 dBf, 2.2 µV/75 ohms 38.3 dBf, 22.5 µV/75 ohms 11.2 dBf, 1 µV/75 ohms 76 dB 70 dB 0.3% 0.5% 45 dB at 1 kHz 30 Hz ­ 15 kHz, +0.5/­2 dB 60 dB at 400 kHz ­ Continued on next page ­ 20 Hz ­ 50 kHz +0/­0.5 dB (with bass boost and tone bypassed) Inputs (Analog) CD, MD/TAPE, VIDEO 1, 2 Sensitivity: 500 mV Impedance: 50 kilohms S/N 2) : 85 dB (A, 500 mV 3) ) 2) INPUT SHORT (with bass boost and tone bypassed). 3) Weighted network, input level. FM STEREO/FM-AM RECEIVER 9-877-864-03 2006B04-1 © 2006. 02 Sony Corporation Home Audio Division Published by Sony Techno Create Corporation 1 STR-DE197 AM tuner section Tuning range Models of area code US, CND With 10-kHz tuning scale: 530 ­ 1,710 kHz 4) With 9-kHz tuning scale: 531 ­ 1,710 kHz 4) Models of area code AEP With 9-kHz tuning scale: 531 ­ 1,602 kHz Antenna Intermediate frequency Usable sensitivity S/N Harmonic distortion Selectivity At 9 kHz: At 10 kHz: Loop antenna 450 kHz 50 dB/m (at 1,000 kHz or 999 kHz) 54 dB (at 50 mV/m) 0.5 % (50 mV/m, 400 Hz) 35 dB 40 dB SAFETY CHECK-OUT After correcting the original service problem, perform the following safety check before releasing the set to the customer: Check the antenna terminals, metal trim, "metallized" knobs, screws, and all other exposed metal parts for AC leakage. Check leakage as described below. LEAKAGE TEST The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a return to chassis, must not exceed 0.5 mA (500 microamperes). Leakage current can be measured by any one of three methods. 1. A commercial leakage tester, such as the Simpson 229 or RCA WT-540A. Follow the manufacturers' instructions to use these instruments. 2. A battery-operated AC milliammete