Teac SRL30DAB free download

File name Teac-SRL35 wall cd rec.pdf

SR-L35 WALL-MOUNTABLE CD RECEIVER PC board shown are viewed from parts side. The parts with no reference number or no parts number in the exploded views are not supplied. As regards the resistors and capacitors, refer to the circuit diagrams contained in this manual. ! 1 SPECIFICATIONS 2 SAFETY INFORMATION 3 ADJUSTMENT AND CHECKS 4 EXPLODED VIEW AND PARTS LIST 5 PC BOARDS AND PARTS LISTS 6 WIRING DIAGRAM 7 INCLUDED ACCESSORIES 2 3 4 7 12 20 22 Parts marked with this sign are safety critical components. they must be replaced with identical components - refer to the appropriate parts list and ensure exact replacement. [T/C]: UL/CSA [E]: EUROPE [UK]: U.K. SR-L35 1 SAFETY INFORMATION SAFETY INFORMATION This product has been designed and manufactured according to FDA regulations " title 21, CFR, chapter 1,subchapter J,based on The Radiation Control for Health and Safety Act of 1968" and is classified as class 1 laser product. There is not hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is shown 1 . CAUTION USE OF CONTROLS OR ADJUSTMENT OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. DO NOT REMOVE THE PROTECTIVE HOUSING USING SCREWDRIVER. IF THIS PRODUCT DEVELOPS TROUBLE, MAKE A CONTACT WITH OUR SERICEMAN, AND DO NOT USE THE PRODUCT A TROUBLED STATE. MODEL NO.SR-L35 CD RECEIVER DC12V TOKYO JAPAN CLASS 1 LASER PDODUCT LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT Optical pickup: Type : CMS-M95BG6 Manufacturer : Samsung Electro-Mechanic Laser output : Less than 0.5 mW on the objective lens Wavelength : 760 -800 nm 2 SR-L35 3 ADJUSTMENTS AND CHECKS 3-1 TUNER SECTION Use a screwdriver with a plastic or ceramic grip for all adjustment. 3-1-1 FM adjustment 1. Set the function switch to the TUNER position. 2. Set the BAND switch to the FM position. 3. Connect the signal generator output through a 75 ohm dummy antenna to "ANT" on MAIN PCB. 4. Connect the oscilloscope to the PHONES JACK terminal. 5. Connect the digital multimeter to Q16(C) on MAIN PCB. 6. Set the signal generator as listed in the alignment chart. 3-1-2 AM adjustment 1. Set the function switch to the TUNER position. 2. Set the BAND switch to the AM position. 3. Connect the test loop antenna across the output of the signal generator. 4. Connect the oscilloscope to the PHONES JACK terminal. 5. Connect the digital multimeter to Q16(C) on MAIN PCB. 6. Set the signal generator as listed in the alignment chart. 3-2 Adjustment and Test Points MAIN PCB TC1 L3 AM ANT COIL L2 L1 Q16 4 SR-L35 3-2-1 AM Tuner ITEM SG SETTING TUNER SETTING ADJUSTMENT MEASURING POINTS. RESULT AM 1710kHz (USA) 1. VOLTAGE adjustment 1620kHz (EUR) 520kHz (USA) 522kHz (EUR) 450kHz 1kHz, 30% mod 600kHz (USA) 603kHz (EUR) 1kHz, 30% mod 1400kHz (USA) 1404kHz (EUR) 1kHz, 30% mod Repeat step 3 600kHz (USA